How to clear CMOS via battery removal

Message Topic Search Topic Options Post Reply Create New Topic Printable Version Translate Topic

   I have found myself giving the same advice in many threads so I have decided to place the information here. 
The clear CMOS jumper and reset factory defaults are not always effective in solving BIOS value corruption and so the only other recourse is to remove the CMOS battery. Many people are aware of this method but fairly often it is not done correctly and hence does not resolve the issue. Below I will outline a foolproof method to achieve a full CMOS clear.

1. Disconnect the system's power from the wall
2. Press and hold the power button for 10 seconds to be sure residual power is discharged
3. Place the "Clear CMOS" jumper in the clear position
4. Remove the CMOS battery
5. Leave the system in this state for 4 hours. 10 minutes is enough in most cases but if that yields no result then to be absolutely certain CMOS is clear I recommend 4 hours.
6. Place the "Clear CMOS" jumper back in its original position
7. Replace the CMOS battery
8. Power on the system

This method should effectively rule out BIOS value corruption as a culprit during troubleshooting. 

BIOS value corruption = corrupted settings in the BIOS
BIOS corruption = Corrupt BIOS/UEFI firmware due to a bad flash

Author	Message Topic Search Topic Options Post Reply Create New Topic Printable Version Translate Topic
Xaltar Members Profile Send Private Message Find Members Posts Add to Buddy List Moderator Group Joined: 16 May 2015 Location: Europe Status: Offline Points: 24653	Topic: How to clear CMOS via battery removal Posted: 12 Aug 2015 at 9:08pm
	I have found myself giving the same advice in many threads so I have decided to place the information here. The clear CMOS jumper and reset factory defaults are not always effective in solving BIOS value corruption and so the only other recourse is to remove the CMOS battery. Many people are aware of this method but fairly often it is not done correctly and hence does not resolve the issue. Below I will outline a foolproof method to achieve a full CMOS clear. 1. Disconnect the system's power from the wall 2. Press and hold the power button for 10 seconds to be sure residual power is discharged 3. Place the "Clear CMOS" jumper in the clear position 4. Remove the CMOS battery 5. Leave the system in this state for 4 hours. 10 minutes is enough in most cases but if that yields no result then to be absolutely certain CMOS is clear I recommend 4 hours. 6. Place the "Clear CMOS" jumper back in its original position 7. Replace the CMOS battery 8. Power on the system This method should effectively rule out BIOS value corruption as a culprit during troubleshooting. BIOS value corruption = corrupted settings in the BIOS BIOS corruption = Corrupt BIOS/UEFI firmware due to a bad flash