Rack - E3C236D2I Unable to use SATA0

Message Topic Search Topic Options Post Reply Create New Topic Printable Version Translate Topic

   Im using the asrock rack E3C236D2I. I know the M.2 and SATA0 have a shared PCI-e lane. I am not using the M.2 drive. I cannot use the SATA0 and refuses to aknoweldge there is a drive connceted.

The manual states:
"The M.2 slot (M2_1) is shared with the SATA_0 connector. When M2_1 is populated with a M.2 SATA3 module, SATA_0 is disabled." But the M.2 slot is not populated.

In the storage section I noticed this:
"SATA/M.2_SATA Mode Selection
Identify the SATA/M.2_SATA port is connected to Solid State Drive or Hard Disk Drive.
Press <Ctrl+I> to enter RAID ROM during UEFI POST process."

This kind of freaks me out, I dont want to RAID my drives, they have data on already, so I discconected them and tried this by enableing RAID mode saving and pressing Ctrl+I at post, but it cycles back to bios and doesnt recongise my input. 

How can I get SATA0 to function?

Author	Message Topic Search Topic Options Post Reply Create New Topic Printable Version Translate Topic
Brownz Members Profile Send Private Message Find Members Posts Add to Buddy List Newbie Joined: 8 hours 21 minutes ago Status: Offline Points: 20	Post Options Post Reply Quote Brownz Report Post Thanks(0) Quote Reply Topic: Rack - E3C236D2I Unable to use SATA0 Posted: 8 hours 8 minutes ago at 3:00am
	Im using the asrock rack E3C236D2I. I know the M.2 and SATA0 have a shared PCI-e lane. I am not using the M.2 drive. I cannot use the SATA0 and refuses to aknoweldge there is a drive connceted. The manual states: "The M.2 slot (M2_1) is shared with the SATA_0 connector. When M2_1 is populated with a M.2 SATA3 module, SATA_0 is disabled." But the M.2 slot is not populated. In the storage section I noticed this: "SATA/M.2_SATA Mode Selection Identify the SATA/M.2_SATA port is connected to Solid State Drive or Hard Disk Drive. Press <Ctrl+I> to enter RAID ROM during UEFI POST process." This kind of freaks me out, I dont want to RAID my drives, they have data on already, so I discconected them and tried this by enableing RAID mode saving and pressing Ctrl+I at post, but it cycles back to bios and doesnt recongise my input. How can I get SATA0 to function?