Is my C2750D4I dead?

Message Topic Search Topic Options Post Reply Create New Topic Printable Version Translate Topic

   Hi,

I have a FreeNAS computer based on the C2750D4i motherboard.  I was trying to do an upgrade to FreeNas 9.10 with bigger drives and a new case.  When I moved the motherboard to the new case it basically stopped working.  The system wont even power up.

I've tried removing it from the case and disconnecting everything except for a single memory stick in A1.  I've also tried to clear the CMOS settings but still nothing.

I'd just assume that it's dead except I'm getting flashing green lights when I supply power.  I think that might be the IPMI module but since I can't get into the BIOS to set the IP address I don't think I'm going to be able to talk to the board.

When I power it on, a green light towards the middle comes on.  After about 30+ seconds it goes off for a while then I get four short blinks and three fast blinks. 

Does anyone have any suggestions as to what I can do to resurrect this thing?

Author	Message Topic Search Topic Options Post Reply Create New Topic Printable Version Translate Topic
jgold Members Profile Send Private Message Find Members Posts Add to Buddy List Newbie Joined: 09 May 2016 Status: Offline Points: 3	Post Options Post Reply Quote jgold Report Post Thanks(0) Quote Reply Topic: Is my C2750D4I dead? Posted: 10 May 2016 at 11:20am
	Hi, I have a FreeNAS computer based on the C2750D4i motherboard. I was trying to do an upgrade to FreeNas 9.10 with bigger drives and a new case. When I moved the motherboard to the new case it basically stopped working. The system wont even power up. I've tried removing it from the case and disconnecting everything except for a single memory stick in A1. I've also tried to clear the CMOS settings but still nothing. I'd just assume that it's dead except I'm getting flashing green lights when I supply power. I think that might be the IPMI module but since I can't get into the BIOS to set the IP address I don't think I'm going to be able to talk to the board. When I power it on, a green light towards the middle comes on. After about 30+ seconds it goes off for a while then I get four short blinks and three fast blinks. Does anyone have any suggestions as to what I can do to resurrect this thing?