b850 pro-a wifi No POST

Message Topic Search Topic Options Post Reply Create New Topic Printable Version Translate Topic

   b850 pro-a wifi asrock, doesn't POST, it shows red LED, sends power to mouse but not keyboard through USB. After a few seconds it flicks directly to green light and is stuck there.

Nu signal to monitor.
Tested without GPU card, only through cpu and internal graphics.

Tested by reseating ram modules, tested with just one module in different slots.

Removed battery for cmos reset.

I'm a bit lost on what the leds are trying to tell might be the problem with the way it acts. 

Author	Message Topic Search Topic Options Post Reply Create New Topic Printable Version Translate Topic
ztilleto Members Profile Send Private Message Find Members Posts Add to Buddy List Newbie Joined: Yesterday Location: Denmark Status: Offline Points: 15	Post Options Post Reply Quote ztilleto Report Post Thanks(0) Quote Reply Topic: b850 pro-a wifi No POST Posted: 14 hours 35 minutes ago at 5:08pm
	b850 pro-a wifi asrock, doesn't POST, it shows red LED, sends power to mouse but not keyboard through USB. After a few seconds it flicks directly to green light and is stuck there. Nu signal to monitor. Tested without GPU card, only through cpu and internal graphics. Tested by reseating ram modules, tested with just one module in different slots. Removed battery for cmos reset. I'm a bit lost on what the leds are trying to tell might be the problem with the way it acts.

Xaltar Members Profile Send Private Message Find Members Posts Add to Buddy List Moderator Group Joined: 16 May 2015 Location: Europe Status: Offline Points: 40623	Post Options Post Reply Quote Xaltar Report Post Thanks(0) Quote Reply Posted: 13 hours 31 minutes ago at 6:12pm
	What are your full system specs? CPU: RAM: Power supply: GPU: Drive/s: What diagnostic lights come on when you power the system? There are 4 of them on the upper right corner of the board just above the 24pin power header. CPU, DRAM etc. A green light indicates that it completed power on self tests successfully for that particular component (CPU, RAM, Boot etc). Your RAM should be in slots A2 and B2 on the board. Make sure they are properly seated in the slots as they can be tight on new boards. Don't use too much force but enough to make sure they are fully inserted.