ASRock.com Homepage
Forum Home Forum Home > Technical Support > AMD Motherboards
  New Posts New Posts RSS Feed - B550M-HDV + Ryzen 5 5600X no POST
  FAQ FAQ  Forum Search   Events   Register Register  Login Login

B550M-HDV + Ryzen 5 5600X no POST

 Post Reply Post Reply
Author
Message
wenny0501 View Drop Down
Newbie
Newbie


Joined: 2 hours 55 minutes ago
Status: Offline
Points: 15
Post Options Post Options   Thanks (0) Thanks(0)   Quote wenny0501 Quote  Post ReplyReply Direct Link To This Post Topic: B550M-HDV + Ryzen 5 5600X no POST
    Posted: 2 hours 38 minutes ago at 2:57am
Because I just registered, can't post new thread in "AMD motherboard" section, so I try to post my question here:
B550M-HDV + Ryzen 5 5600X: 5 short beeps, no video (3200G works)
Board: ASRock B550M-HDV, BIOS P4.21 (latest), CMOS cleared. RAM: Teamgroup DDR4-3200 2x16GB (also tried single sticks in each slot). Minimal setup: PSU, board, CPU, RAM, GPU, keyboard, speaker.
Ryzen 3 3200G: my original CPU for several years, works normally with Radeon HD 6450 and RTX 2060 Super, video on all monitors. When no RAM: 3 long beeps.
Ryzen 5 5600X (same board, RAM, no matter which GPU): always 5 short beeps, no video.when no RAM: silent.
Pins inspected and cleaned (there was some thermal paste between pins). Is CPU Ryzen 5 5600X faulty, or is there a BIOS setting or board issue I should check? Thanks.
Back to Top
Xaltar View Drop Down
Moderator Group
Moderator Group
Avatar

Joined: 16 May 2015
Location: Europe
Status: Offline
Points: 44438
Post Options Post Options   Thanks (0) Thanks(0)   Quote Xaltar Quote  Post ReplyReply Direct Link To This Post Posted: 49 minutes ago at 4:46am
I am sure this is a stupid question but are you connecting the display cable to
the GPU or the motherboard? I needs to be connected to the GPU with the 5600x as
it has no iGPU. It should have been connected to the GPU before too but it would
have worked connected to the motherboard on the 3200g given it does have an iGPU.

5 beeps usually means no display detected. It can also mean a CPU error but that
is usually caused by an outdated BIOS that doesn't support the CPU. That should
not be the case for you given you updated to 4.21 and your 3200g is working (update
was successful).

If your display cable is connected to the GPU and you still get 5 beeps, try different
display outputs on the GPU. If still no luck then you will want to get the CPU
tested, it could be faulty/defective.

Good luck
Back to Top
 Post Reply Post Reply

Forum Jump Forum Permissions View Drop Down

Forum Software by Web Wiz Forums® version 12.08
Copyright ©2001-2026 Web Wiz Ltd.

This page was generated in 0.125 seconds.