![]() |
B550M-HDV + Ryzen 5 5600X no POST |
Post Reply
|
| Author | |
wenny0501
Newbie
Joined: 14 hours 15 minutes ago Status: Offline Points: 30 |
Post Options
Thanks(0)
Quote Reply
Topic: B550M-HDV + Ryzen 5 5600X no POSTPosted: 13 hours 58 minutes ago at 2:57am |
|
Because I just registered, can't post new thread in "AMD motherboard" section, so I try to post my question here:
B550M-HDV + Ryzen 5 5600X: 5 short beeps, no video (3200G works) Board: ASRock B550M-HDV, BIOS P4.21 (latest), CMOS cleared. RAM: Teamgroup DDR4-3200 2x16GB (also tried single sticks in each slot). Minimal setup: PSU, board, CPU, RAM, GPU, keyboard, speaker. Ryzen 3 3200G: my original CPU for several years, works normally with Radeon HD 6450 and RTX 2060 Super, video on all monitors. When no RAM: 3 long beeps. Ryzen 5 5600X (same board, RAM, no matter which GPU): always 5 short beeps, no video.when no RAM: silent. Pins inspected and cleaned (there was some thermal paste between pins). Is CPU Ryzen 5 5600X faulty, or is there a BIOS setting or board issue I should check? Thanks. |
|
![]() |
|
Xaltar
Moderator Group
Joined: 16 May 2015 Location: Europe Status: Online Points: 44453 |
Post Options
Thanks(0)
Quote Reply
Posted: 12 hours 9 minutes ago at 4:46am |
|
I am sure this is a stupid question but are you connecting the display cable to
the GPU or the motherboard? I needs to be connected to the GPU with the 5600x as it has no iGPU. It should have been connected to the GPU before too but it would have worked connected to the motherboard on the 3200g given it does have an iGPU. 5 beeps usually means no display detected. It can also mean a CPU error but that is usually caused by an outdated BIOS that doesn't support the CPU. That should not be the case for you given you updated to 4.21 and your 3200g is working (update was successful). If your display cable is connected to the GPU and you still get 5 beeps, try different display outputs on the GPU. If still no luck then you will want to get the CPU tested, it could be faulty/defective. Good luck
|
|
|
|
![]() |
|
wenny0501
Newbie
Joined: 14 hours 15 minutes ago Status: Offline Points: 30 |
Post Options
Thanks(0)
Quote Reply
Posted: 8 hours 1 minutes ago at 8:54am |
|
Thank you for your rapid response. No matter with Ryzen 3 3200g or Ryzen 5 5600x, monitor cables are always connected to GPU, not on motherboard ports. And always 2 monitor cables, 1 is hdmi and another is DVI to Radeon HD 6450, 1 is hdmi and another is DP to rtx 2060.
I know it's not easy to do a conclusion that Ryzen 5 5600x is faulty. |
|
![]() |
|
Xaltar
Moderator Group
Joined: 16 May 2015 Location: Europe Status: Online Points: 44453 |
Post Options
Thanks(0)
Quote Reply
Posted: 2 hours 54 minutes ago at 2:01pm |
|
You have pretty much done everything I would suggest to troubleshoot, the last thing
you can try is this. If there is any corrupt BIOS values that should clear it. 10 mins is typically enough. The display cables were the only thing I could really think of as a possible cause outside of a faulty CPU. Some people with an APU like to connect the cables to the motherboard, using the APU's iGPU as the default output allows for lower power draw while performing non GPU intensive tasks and the dGPU takes over for things like gaming/rendering. The only other thing you can try (if you haven't already) is a single stick of RAM when using the 5600x. If it POSTs with a single stick then you can shut down and install the second stick. I have seen this behavior before, it usually resolves as soon as you can get the system to POST. If you can find someone to test your 5600x that would be the next step. |
|
|
|
![]() |
|
Post Reply
|
|
| Tweet |
| Forum Jump | Forum Permissions ![]() You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |