H110 pro btc+ Onboard Graphics Problem

Message Topic Search Topic Options Post Reply Create New Topic Printable Version Translate Topic

   Hello,
I have a problem with my setup:

- Mainboard asrock h110 pro btc+
- CPU Intel Cleron G4920 Socket 1151 LGA
- RAM DDR4 3200Mhz set to 2400
- 13 x graphics cards

I wanted to use the internal graphics card.
For this I have activated it and also selected it as primary, because I would like to have a small monitor on it for safety.
When I do that and get into Windows and the drivers are installed, it throws the video cards out at me.
Then I get the driver code 3 error.
I have so far
- Reinstalled the drivers with DDU
- All drivers out and new again
- External graphics card used to test but there is nothing more.

After much back and forth it now runs again when I disable it in the bios.

Can it be that the CPU can not do both?
Did I do something wrong?

I apologize now for my bad English.

Thanks a lot

Author	Message Topic Search Topic Options Post Reply Create New Topic Printable Version Translate Topic
DerM91 Members Profile Send Private Message Find Members Posts Add to Buddy List Newbie Joined: 11 Apr 2021 Status: Offline Points: 40	Post Options Post Reply Quote DerM91 Report Post Thanks(0) Quote Reply Topic: H110 pro btc+ Onboard Graphics Problem Posted: 11 Apr 2021 at 8:52pm
	Hello, I have a problem with my setup: - Mainboard asrock h110 pro btc+ - CPU Intel Cleron G4920 Socket 1151 LGA - RAM DDR4 3200Mhz set to 2400 - 13 x graphics cards I wanted to use the internal graphics card. For this I have activated it and also selected it as primary, because I would like to have a small monitor on it for safety. When I do that and get into Windows and the drivers are installed, it throws the video cards out at me. Then I get the driver code 3 error. I have so far - Reinstalled the drivers with DDU - All drivers out and new again - External graphics card used to test but there is nothing more. After much back and forth it now runs again when I disable it in the bios. Can it be that the CPU can not do both? Did I do something wrong? I apologize now for my bad English. Thanks a lot

LST1977 Members Profile Send Private Message Find Members Posts Add to Buddy List Newbie Joined: 13 Apr 2021 Location: Switzerland Status: Offline Points: 15	Post Options Post Reply Quote LST1977 Report Post Thanks(0) Quote Reply Posted: 13 Apr 2021 at 3:30pm
	I have the same issue, when switching to onboard graphics in BIOS. I have a: - ASROCK H110 pro BTC+ - Intel i5 - 6600 and 10 GPUs - Server PSU The display shows up when I connect to GPU, but not on Onboard GPU. There was also a discussion in 2018 in this forum, however there was no solution at the end... Best Lorenz