Issue with Z390 Phantom itx and Intel 8600k

Message Topic Search Topic Options Post Reply Create New Topic Printable Version Translate Topic

   Hello everyone,

I?�m building my first Windows PC. I wanted an itx mini board and picked this up from Amazon.

I purchased a Seasonic 650w PSU, Crucial Ballistix 3000mhz ram, Intel 7600p M.2 and Intel i5-6800k

When I first put the PC together. The MOBO had three red LEDs pulsing but would not post nor did I get anything from the integrated hdmi port. The system would also shut off after about a minute or so.

I checked the cpu cooler to make sure there was a thin layer of paste, reseated the CPU just in case and then I had two red leds pulsing on the MOBO. Still shutting down after a minute or so.

I?�m stumped and I don?�t know how to get this to post.

I took pictures of the MOBO pins, bottom of the CPU and the thermal paste I used in case that was an issue.

This cpu is compatible with all BIOs versions but I believe my version is 1.50 however I can?�t boot into the bios so I?�m unsure. 

Any help would be appreciated.

Author	Message Topic Search Topic Options Post Reply Create New Topic Printable Version Translate Topic
JazzKnight Members Profile Send Private Message Find Members Posts Add to Buddy List Newbie Joined: 19 Nov 2019 Location: Las Vegas Status: Offline Points: 3	Post Options Post Reply Quote JazzKnight Report Post Thanks(0) Quote Reply Topic: Issue with Z390 Phantom itx and Intel 8600k Posted: 19 Nov 2019 at 3:42pm
	Hello everyone, I?�m building my first Windows PC. I wanted an itx mini board and picked this up from Amazon. I purchased a Seasonic 650w PSU, Crucial Ballistix 3000mhz ram, Intel 7600p M.2 and Intel i5-6800k When I first put the PC together. The MOBO had three red LEDs pulsing but would not post nor did I get anything from the integrated hdmi port. The system would also shut off after about a minute or so. I checked the cpu cooler to make sure there was a thin layer of paste, reseated the CPU just in case and then I had two red leds pulsing on the MOBO. Still shutting down after a minute or so. I?�m stumped and I don?�t know how to get this to post. I took pictures of the MOBO pins, bottom of the CPU and the thermal paste I used in case that was an issue. This cpu is compatible with all BIOs versions but I believe my version is 1.50 however I can?�t boot into the bios so I?�m unsure. Any help would be appreciated.