X399M Raid 0 Fresh Install

Message Topic Search Topic Options Post Reply Create New Topic Printable Version Translate Topic

   Figured it out for anyone else wondering. Needed to format the raid 0 array to GPT.

The way you do this, continue to booting up as if you are going to install windows 10. Click repair instead of install.

Run the Command prompt.
Type "diskpart" in the command prompt. Then type "list disk" and it will show you the drive arrays. Find the raid 0 array that you wish to format, mine was 0.

Then type "select disk 0" change the 0 to your array that you want.
Type "clean"
Type "convert gpt"
Type "exit"

Now reboot and install the 3 raid drivers again. It should now let you continue to install Windows 10.

Author	Message Topic Search Topic Options Post Reply Create New Topic Printable Version Translate Topic
jepsii Members Profile Send Private Message Find Members Posts Add to Buddy List Newbie Joined: 23 Nov 2020 Status: Offline Points: 4	Post Options Post Reply Quote jepsii Report Post Thanks(0) Quote Reply Topic: X399M Raid 0 Fresh Install Posted: 23 Nov 2020 at 5:31pm
	Figured it out for anyone else wondering. Needed to format the raid 0 array to GPT. The way you do this, continue to booting up as if you are going to install windows 10. Click repair instead of install. Run the Command prompt. Type "diskpart" in the command prompt. Then type "list disk" and it will show you the drive arrays. Find the raid 0 array that you wish to format, mine was 0. Then type "select disk 0" change the 0 to your array that you want. Type "clean" Type "convert gpt" Type "exit" Now reboot and install the 3 raid drivers again. It should now let you continue to install Windows 10.

jepsii Members Profile Send Private Message Find Members Posts Add to Buddy List Newbie Joined: 23 Nov 2020 Status: Offline Points: 4	Post Options Post Reply Quote jepsii Report Post Thanks(0) Quote Reply Posted: 23 Nov 2020 at 1:29pm
	Hello everyone. I was trying to do a fresh windows 10 install on my PC, due to issues with Windows Updates being unable to update and causing issues. I've had this PC for 3 years running Raid 0. Well, I currently have a X399M Taichi and have used it in Raid 0 with 3 m.2 nvme's, without issues. I loaded the correct drivers from ASRock and it shows the correct array. However, I am getting an issue with it not allowing me to load windows onto it. It states "Windows can't be installed on drive 0 partition 1. Windows cannot be installed to this disk. This computer's hardware may not support booting to this disk. Ensure that the disk's controller is enabled in the computer's BIOS menu. I am loading windows off of a USB stick and never had problems in the past. Any ideas on what I can do to correct this? Thank you