fatal1ty ab350 gaming k4 ram

Hi all, 

Sorry to resurrect this post, but any updates with those Hynix chips after the most recent Bios update? 

potyec
your ram as said is hynix m die
the stated 3200 timings are stated there in the report screen shot
16/18/18/36 @ 1.35 volts

you could see if the xmp sets it to this or even manually trying these

at present if the bios allows it and the system is stable consider yourself lucky
i do expect after the may release from amd of agesa code 1005 to the board makers for ram support to improve greatly (and by this i mean sticks of ram working automatically at correct design settings) not just the amount of ram brands supported

its early days ,ryzen has been overall quite a success for a brand new platform
some of us older guys have seen new platforms launch over many years
these issues are not something new ,its been like this many times before
im trying to assist another forum member here with what should have been the very best choice of ram for ryzen,but hes stuck at 2133, so if your hynix sticks are doing better your a bit more lucky than others
i would assume within 30 days (mid may) all the board makers will have the later bios out with the 1005 code and many headaches will be distant memories

datonyb wrote: the timings you can set and use will depend on your bios version/motherboard and ram models i would check on rymem and see what others have run on your board and ram combo the ram i am using is the one type that seem consistantly to give the best luck eg samsung b dies my rams labelled timings are 15/15/15/35 but even manually setting this and the bios showing this when i boot into windows and check its set to 16/15/15 which is wierd because any other setting will stay what i enter in bios eg 14/14/14 im leaving it at current setting until the may release of amd agesa 1005 and then will have a play again to see what i can get out of the ram (on intel systems these sticks clock anywhere upto 4000 speed )

datonyb wrote: ive done it with the taichi and gskill tridentz but it simply will not cold boot with the cl14 settings (it runs benches and tests forever when rebooting from bios into windows no problems ,but if shut down will not boot again) http://valid.x86.fr/4ws90d that was my best stable windows 14/13/13/13/35 @ 3200 1.35 volts but i have to run at 16/15/15/15/35 for a cold boot

Edited by potyec - 15 Apr 2017 at 3:12pm