![]() |
RAM cannot overclocking |
Post Reply ![]() |
Author | |
Xaltar ![]() Moderator Group ![]() ![]() Joined: 16 May 2015 Location: Europe Status: Offline Points: 26933 |
![]() ![]() ![]() ![]() ![]() Posted: 25 May 2018 at 5:45pm |
If you look at Support's pics, you will see they used BIOS 4.60 for testing. If you are using an older BIOS version that could be where the problem is coming from
![]() |
|
![]() |
|
![]() |
|
ASRock_TSD ![]() ASRock_Official ![]() Joined: 20 Mar 2015 Status: Offline Points: 8907 |
![]() ![]() ![]() ![]() ![]() |
Dear Nayeli, Greetings, this is ASRock TSD. We install two DDR4-3000 8GB RAM on DIMM A2 and B2. Then enable XMP profile to work at 2933 speed. ![]() After that, we connect two SSD 256GB on SATA ports. Then we set up to RAID mode, and configure a RAID0 volume in RAID ROM interface. We enter to BIOS and check the DRAM speed is still at 2933. ![]() For this case, we provide following suggestions: 1. Please install memory on A2 and B2 slot. 2. Please re-load XMP profile and set DRAM frequency manually. 3. Please increase a little DRAM voltage for verifying. 4. Please loose the DRAM timing. 5. Please delete the RAID0 volume and follow above suggestions to check again. Then create RAID0. Thanks! All the best, ASRock TSD |
|
![]() |
|
Nayeli ![]() Newbie ![]() Joined: 11 Nov 2017 Status: Offline Points: 17 |
![]() ![]() ![]() ![]() ![]() |
![]() |
Post Reply ![]() |
|
Tweet
|
Forum Jump | Forum Permissions ![]() You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |