AM4 BIOS info

StanleyKessler21 wrote: CPU socket:              Socket AM 4 RAM Technology:          DIMM Chipset Type:            AMD X570 Memory speed:            2133 MHz Memory storage capacity: 128 GB Platform:                 Windows 10 Compatible processor:     AMD 3rd Gen Ryzen Graphic card interface:   PCI Express

No PROBLEM

BIOS version: 2.11 BETA (Agesa 1.2.0.7)
Board: A520M-HVS
CPU: Ryzen 5 5600G
RAM: 2 x 8GB Corsair Vengeance LPX CMK16GX4M2B3200C16 (single-rank)

Two days since update, stable so far. Have not experienced any problems.

My bad! Bios es 7.10, no 7.20! sorry

MB - B550 EX4
CPU - R5 3600 stock
Ram - G.skill GTZR neo 16*2 bus 3600
GPU - RX6600XT
PSU - Super flower 650W gold

stable with bios Vr 2.10 after update bios to 2.30
my pc shuttering sometime and beep 5 short time on startup but work fine sometime

ps.Cant delete my OC profile try to clear cmos but not work

Board model: Fatal1ty AB350 Gaming-ITX/ac
BIOS version: 7.4
CPU: Ryzen 5 5500
RAM: 2 x 8GB Patriot 3200 MHz
GPU: Rx Vega 56

Notes: I upgrade my CPU from Ryzen 5 2400g to Ryzen 5 5500, and my current BIOS version + CPU seems to be working great. I had 2 minor issues with certain BIOS versions / CPUs along the way, and I had 2 minor issues due to poor instructions / installation notes. See below.

Documentation issue #1: I had to flash my motherboard from version 4.6 -> 5.3 -> 7.0 beta -> 7.4. The version 7.4 BIOS notes say you need to update to 7.0, but the BIOS notes for version 7.0 and 7.4 both fail to say you need to update to 5.3 before you update to 7.0. I thought this might be the case because notes versions before 7.0 do mention the need to update to 5.3. Thankfully, the flash process simply did not allow me to install 7.0 directly.

BIOS version 4.6 + 2400g : My graphics card would not output a signal during the boot process. I could only see my boot screen when I connected my monitor directly to the motherboard.

BIOS version 7.4 + 2400g : When I would "restart" my computer, this combination would not post. Thankfully, I could do a full "shutdown", and then my computer would boot correctly.   

Documentation issue #2: I followed the BIOS upgrade instructions precisely (https://www.asrock.com/support/BIOSIG.asp?cat=BIOS10). I checked to see if my system had fTPM enabled, and it appeared to be no. However, after I installed the new CPU, it would not boot. The error message I received said that fTPM was enabled, and it was asking if I wanted to permanently make some changes and risk not being able to boot anymore. I said no. I was able to solve the issue by changing the BIOS fTPM setting from "auto" to "disabled". After this, my computer could boot with no errors. I believe this was an issue because the instructions told me to load the default BIOS settings. I assume that doing so is probably a good idea with a new CPU, but the instructions gave no warning this could cause a scary error message about the fTPM and no instructions on how to resolve it.