RX 6800 XT no LED

Dear Gastrikhell,

Thanks for posting.

If you are using the XT version of the RX6800. Please use the following to try flashing the firmware.
https://download.asrock.com/TSD/Desktop/Tool/RGB%20FW/RX6800XT%20PG.zip

With thanks,
ASRock TSD

I have no light on my RX 6800 XT Phantom Gaming... The switch is ON but it does not work.

I've tried the firmware update in CMD (administrator) but it fails. I'm running Windows 11.

Is it defect?

Я в?кл??ил блок пи?ани? на но?? и ???ом "Update Pass" ?ол?ко ?або?ае? rgb на пе?едней панели, а вен?ил??о? не? rgb

The Firmware Update exe. closed quickly after it completed, i think. i never did see an "update pass" msg before the program closed automatically. ASRoock Tweak appears to have full control over my GPU. no problems there, but still no lights on my gpu, even after reboot.

Dear Winterborn107,

This is ASRock technical support.

Thanks for posting your query to the ASRock forum.

Regarding your question, kindly refer to the followings:
1. Boot up the system and install the graphics card driver.
2. Download the following tool and unzip it.
https://download.asrock.com/TSD/Desktop/Tool/RGB%20FW/RX6800%20PGD%2016GO.zip
3. Run command prompt as Administrator.
4. Go to the directory where the tool is located.
   e.g. Type cd (Directory of the RX6800 PGD 16GO file)
5. Run the update tool by typing "Update_RX6800_PG.cmd"
6. The update process may take a while.
7. When the message "Update Pass" shows up, it means that the graphics card firmware has been flashed successfully.
8. Please turn on the RGB software and check if the RGB can be controlled properly.
https://download.asrock.com/Utility/RGB/PolychromeSYNC(v1.0.26).zip

With thanks,
ASRock TSD

Edited by ASRock_TSD - 07 Dec 2022 at 4:16pm