x370 Taichi RAM problems after 5800x3d upgrade |
Post Reply |
Author | |
ImLost
Newbie Joined: 14 Jun 2023 Status: Offline Points: 35 |
Post Options
Thanks(0)
Posted: 14 Jun 2023 at 11:26pm |
When going from my 3600x to the 5800x3d I updated my bios to 7.00 then 7.10 as per the taichi instructions loading default uefi after each update. However, now when dual channel RAM is installed in either configuration the PC will power cycle with the monitors and debug LED remaining blank. With one stick of RAM in either the A1 or B1 slot the PC will boot and work as intended. I thought it was a bad memory controller on the CPU so I returned it for a new one but the same problem persists. Oh and I also tried the full CMOS reset process by no dice there as well.
Any suggestions on what I could try next would be much appreciated. |
|
cx5
Senior Member Joined: 15 Sep 2017 Location: Hong Kong Status: Offline Points: 2398 |
Post Options
Thanks(0)
|
may be some information here might be of use
https://www.overclock.net/threads/asrock-x370-taichi-overclocking-thread.1627407/page-520 |
|
x370taichi@3.50gen4
AX750 Optane900P SN770 3800x PosdonZro4 BarrowPWM-17w>420x140x28 XFX SWFT319 6900XT MSI RX560 LP to get Fluid Motion BlueskyFRC 75hz |
|
ImLost
Newbie Joined: 14 Jun 2023 Status: Offline Points: 35 |
Post Options
Thanks(0)
|
Tried his voltage advice by no luck, I wonder if it's just the RAM in general being the problem.
Corsair Vengeance LPX 32GB 3600 (PC4-28800) C18 1.35V SKU - CMK32GX4M2D3600C18 |
|
Post Reply | |
Tweet
|
Forum Jump | Forum Permissions You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |