ixtreme 6/3.1 won't post

I've built my pc but now i can't get it to post. I have an iextreme 6/3.1 mobo, 2 x GTX 1080, i7 6800K and 32GB RAM.

The RAM ive tried it GSkillz DDR4 3200Mhz (4 x 8GB) and also Corsair DDR4 2400Mhz.

The board debugger shows error code 53 if no RAM is inserted and 67 (or b7) if I insert any of the RAM.

Ive tried putting 4 sticks in the A1, B1, C1 and D1 slots and also, just having one in the A1 slot.

Ive run out of ideas and don't know what else to try, can anyone think of anything else.

My system is fully liquid cooled so I'm kind of restricted in changing too much without draining it and tearing it down.

The error messages point to a memory error but, idk what else to try.

thanks,

mango

You will need BIOS 3.0 or later to support the 6800k. Check the sticker on your BIOS chips for what version you have. If it is not 3.0 or higher you can either install a supported CPU (Haswell) and update the BIOS or, if you don't have access to a Haswell 2011 CPU you can purchase a new BIOS chip from ASRock preflashed with the BIOS version of your choice.

Visit the support page for more info.

Thank-you for pointing that out, I was losing the will to carry on lol :)

Ok, so now to sort it, I don't think I have access to another processor and the replacement chip seems only available in north America, I'm in the UK.

Do you have any other suggestions for me either getting the chip or updating bios?

there must be a chip I can get my hands on I'm sure.

thanks again though, you've perked me up a little now :)

Can't hurt to ask.

I can drain the loop, thats no prob, idk if theyll be able to flash without me re-filling or if they can do it, ill give them a call and ask.

Once again, thank-you for your help, im back on track again now :)

Thanks.