fatal1ty ab350 gaming k4 ram

y3llo wrote: potyec wrote: Looks like y3llo has exactly the same memory as me . Mine working on 2933 Mhz  . Which timings I should use for 3200 Mhz ? @parsec how do you configure your bios for 2933? I am unable to hit this.

PSA: Double check your manual for correct dual channel memory installation.

I debated whether to mention this, as I it would prove I am complete newb. However for the good of this motherboard and for the G.Skill Flare X, I decided I should take the bullet.

Once I installed the memory in slots A2 and B2, XMP 3200 worked without fuss! Booted right away with timings of 14-14-14-34-73-1T.

http://valid.x86.fr/wksj7u

Now to be fair, I started Ryzen launch on another manufacturer's mobo, where the ram was to be installed in slots 1 and 2. Either way, I messed up, look like a fool, but so happy it is working.

@datonyb thank you for your help. I actually watched your recommended video and followed all your steps to train my memory (when installed incorrectly). I like to think all the boot training I did previously helped the memory work instantly when installed correctly.

TLDR; G.Skill Flare X works with XMP profile on Fatal1ty AB350 Gamin K4 @3200mhz


Edited by y3llo - 14 Apr 2017 at 11:14pm

datonyb wrote: ive done it with the taichi and gskill tridentz but it simply will not cold boot with the cl14 settings (it runs benches and tests forever when rebooting from bios into windows no problems ,but if shut down will not boot again) http://valid.x86.fr/4ws90d that was my best stable windows 14/13/13/13/35 @ 3200 1.35 volts but i have to run at 16/15/15/15/35 for a cold boot

Edited by potyec - 15 Apr 2017 at 3:12pm

datonyb wrote: the timings you can set and use will depend on your bios version/motherboard and ram models i would check on rymem and see what others have run on your board and ram combo the ram i am using is the one type that seem consistantly to give the best luck eg samsung b dies my rams labelled timings are 15/15/15/35 but even manually setting this and the bios showing this when i boot into windows and check its set to 16/15/15 which is wierd because any other setting will stay what i enter in bios eg 14/14/14 im leaving it at current setting until the may release of amd agesa 1005 and then will have a play again to see what i can get out of the ram (on intel systems these sticks clock anywhere upto 4000 speed )

potyec
your ram as said is hynix m die
the stated 3200 timings are stated there in the report screen shot
16/18/18/36 @ 1.35 volts

you could see if the xmp sets it to this or even manually trying these

at present if the bios allows it and the system is stable consider yourself lucky
i do expect after the may release from amd of agesa code 1005 to the board makers for ram support to improve greatly (and by this i mean sticks of ram working automatically at correct design settings) not just the amount of ram brands supported

its early days ,ryzen has been overall quite a success for a brand new platform
some of us older guys have seen new platforms launch over many years
these issues are not something new ,its been like this many times before
im trying to assist another forum member here with what should have been the very best choice of ram for ryzen,but hes stuck at 2133, so if your hynix sticks are doing better your a bit more lucky than others
i would assume within 30 days (mid may) all the board makers will have the later bios out with the 1005 code and many headaches will be distant memories