ASRock.com Homepage
Forum Home Forum Home > Technical Support > Intel Motherboards
  New Posts New Posts RSS Feed - X99 Extreme4/3.1 high temps
  FAQ FAQ  Forum Search Search  Events   Register Register  Login Login

X99 Extreme4/3.1 high temps

 Post Reply Post Reply
Author
Message
Joe America View Drop Down
Newbie
Newbie
Avatar

Joined: 20 Oct 2015
Location: Florida
Status: Offline
Points: 11
Post Options Post Options   Thanks (0) Thanks(0)   Quote Joe America Quote  Post ReplyReply Direct Link To This Post Topic: X99 Extreme4/3.1 high temps
    Posted: 20 Oct 2015 at 9:14pm
I have the asrock x99 extreme4/3.1

I just downloaded Open Hardware Monitor so I could look at my CPU temperatures.
the CPU is fine but there are 6 temperatures on the motherboard and Temperature #6 runs anywhere from 100C to 125C when the PC is at idle , it rarely goes below 100C.

I ran Intel burn test and temperature #6 drops do 30C and stays there until the test is over, then it's back to 125C.

my questions are
what is the motherboard temperature #6?
what if anything can I do to bring this temperature down?
Back to Top
parsec View Drop Down
Moderator Group
Moderator Group
Avatar

Joined: 04 May 2015
Location: USA
Status: Offline
Points: 4996
Post Options Post Options   Thanks (0) Thanks(0)   Quote parsec Quote  Post ReplyReply Direct Link To This Post Posted: 21 Oct 2015 at 12:58am
Those crazy high temperature reading you see are simply unused outputs on the board's sensor chip. The readings are just random data and not a true reading of a temperature.

Programs like Open Hardware Monitor can only guess which sensor outputs are being used, as there is no standard used by mother board manufactures. These programs would need to be customized for every mother board to only display the sensor outputs that are meaningful. I'm also sure that it does not display all of the sensor outputs that are being used.

The only monitoring program that I have found that even comes close to being configured for different mother boards is HWiNFO64. But it will still display some of the unused sensor chip outputs, since mother board manufactures do not make information available about which sensor outputs are being used.

Your question is a very common one, we see it all the time in PC forums. But you have nothing to worry about.

The only monitoring program that is customized for your board is the one provided by ASRock, A-Tuning.
Back to Top
Joe America View Drop Down
Newbie
Newbie
Avatar

Joined: 20 Oct 2015
Location: Florida
Status: Offline
Points: 11
Post Options Post Options   Thanks (0) Thanks(0)   Quote Joe America Quote  Post ReplyReply Direct Link To This Post Posted: 21 Oct 2015 at 4:09am
thanks you so much, that answers my question perfectly.
Back to Top
 Post Reply Post Reply
  Share Topic   

Forum Jump Forum Permissions View Drop Down

Forum Software by Web Wiz Forums® version 12.04
Copyright ©2001-2021 Web Wiz Ltd.

This page was generated in 4.875 seconds.