![]() |
AM4 BIOS info |
Post Reply
|
Page <1 1112131415 17> |
| Author | |
Manp
Newbie
Joined: 24 Oct 2020 Status: Offline Points: 18 |
Post Options
Thanks(0)
Quote Reply
Posted: 04 Dec 2020 at 10:40pm |
|
Board model: B550 Phantom Gaming-ITX/ax
BIOS version: 1.50 1.60 1.61 1.71 (all AGESA 1.1.0.0 based) CPU: Ryzen 5 3600x RAM: Corsair Vengeance RGB Pro 16GB (2x8GB) @ XMP 3600 C18 or Crucial Ballistix BL2K8G36C16U4WL RGB @ XMP 3600 CL16CL16 Notes: tons of WHEA errors logged. System randomly reboots under light load or high load. Both memory kits runs fine with zero WHEA errors on a Gigabyte x570 AORUS Elite MB with every AGESA 1.1.0.0 based BIOSes (beta and non beta) Board model: B550 Phantom Gaming-ITX/ax BIOS version: 1.20 (AGESA 1.0.8.0 based) CPU: Ryzen 5 3600x RAM: Corsair Vengeance RGB Pro 16GB (2x8GB) @ XMP 3600 C18 or Crucial Ballistix BL2K8G36C16U4WL RGB @ XMP 3600 CL16 Notes: Sytem is perfectly stable. BIOS seems to automatically apply an overvolt to SOC @ 1,2 volts when XMP is enabled. I can manually set VSOC to 1.1 volts with no loss of stability. i see a huge regression here. |
|
![]() |
|
ThreeDee
Senior Member
Joined: 24 Jul 2019 Location: Billings,MT Status: Offline Points: 2396 |
Post Options
Thanks(0)
Quote Reply
Posted: 04 Dec 2020 at 5:49pm |
|
Board: X570 Taichi
BIOS: 3.80 beta CPU: AMD Ryzen 7 3700X RAM: 32GB, 2 x 16GB HyperX Predators 3200@3600 CAS 16 Issue: None through preliminary testing so far |
|
|
|Ryzen 5 5900|ASRock X570 Taichi-BIOS 4.60|2x16GB HyperX Predator RGB 3200@3600 1:1 IF|ASRock RX 6700XT|2 x PCIe 4.0 M.2 Drives for OS & Games|850 WTT Seasonic 80+ Titanium PSU|Noctua NH-D15|
|
|
![]() |
|
BerndGaykema
Newbie
Joined: 10 Nov 2019 Location: Netherlands Status: Offline Points: 124 |
Post Options
Thanks(0)
Quote Reply
Posted: 04 Dec 2020 at 12:06am |
|
Board: X570 Creator
BIOS: 3.30 beta CPU: AMD Ryzen 7 3800X RAM: 32GB, 2 x 16GB Corsair Vengeance LPX CMK32GX4M in slots A2 and B2 Issue: Boot loop when XMP-settings are applied, on AUTO it works OK (but much slower than possible). Versions 3.0 and earlier where OK, XMP-settings could be applied. |
|
|
X570 Creator, Ryzen 7 3800X, Corsair Vengeance LPX 2x16GB 3200 CMK32GX4M, Kingston NVMe A2000 500GB (OS), 1000GB (Data).
|
|
![]() |
|
BerndGaykema
Newbie
Joined: 10 Nov 2019 Location: Netherlands Status: Offline Points: 124 |
Post Options
Thanks(0)
Quote Reply
Posted: 02 Dec 2020 at 2:22am |
|
Board: X570 Creator
BIOS: Both 3.14 beta and 3.15 beta CPU: AMD Ryzen 7 3800X RAM: 32GB, 2 x 16GB Corsair Vengeance LPX CMK32GX4M in slots A2 and B2 Issue: Boot loop when XMP-settings are applied, on AUTO it works OK (but much slower than possible). Versions 3.0 and earlier where OK, XMP-settings could be applied. |
|
|
X570 Creator, Ryzen 7 3800X, Corsair Vengeance LPX 2x16GB 3200 CMK32GX4M, Kingston NVMe A2000 500GB (OS), 1000GB (Data).
|
|
![]() |
|
Krzysztof903
Newbie
Joined: 25 May 2020 Status: Offline Points: 12 |
Post Options
Thanks(0)
Quote Reply
Posted: 24 Nov 2020 at 7:50pm |
|
https://megawrzuta.pl/download/41cd4147da39dcf95cb3787ca6b8e5bf.html
|
|
![]() |
|
Krzysztof903
Newbie
Joined: 25 May 2020 Status: Offline Points: 12 |
Post Options
Thanks(0)
Quote Reply
Posted: 24 Nov 2020 at 6:21pm |
|
Model p?ytki: X570 steel legend
Wersja BIOS: P3.31 Procesor: 5800x RAM: GOODRAM 32GB (2x16GB) 3600MHz CL17 IRDM PRO, Patriot viper 4 2x4GB 3000mhz cl 16 because the processor is loaded, the board starts, the cpu and ram diodes are on and then after a few seconds it restarts, I tested on both bones. the previous CPU on this plate, the 3200G, works with these frame bones without fear, while on the b450 pro 4, the 5800x starts with these bones without fear. Faulty bios probably came out for this album |
|
![]() |
|
ThreeDee
Senior Member
Joined: 24 Jul 2019 Location: Billings,MT Status: Offline Points: 2396 |
Post Options
Thanks(0)
Quote Reply
Posted: 24 Nov 2020 at 5:22pm |
https://forum.level1techs.com/t/list-of-dr-debug-bios-codes/114364 Board model: X570 Taichi BIOS version: Both 3.60 and 3.61 CPU: Ryzen 7 3700X RAM:2 x 16GB Hyperx Predators 3200 CAS16 won't load saved profiles and cannot run my RAM at 3600 CAS16 w/IF 1800 Reverted back to AGESA Combo-AM4 V2 1.0.8.0 (3.40) I had the same issue on the x570 Steel Legend with AGESA Combo-AM4 V2 1.1.0.0 and up and reverted back to 3.00 on that motherboard. Board model: X570 Taichi BIOS version: 3.40 CPU: Ryzen 7 3700X RAM:2 x 16GB Hyperx Predators 3200 CAS16 @ 3600 CAS16 w/IF @ 1800, no issues |
|
|
|Ryzen 5 5900|ASRock X570 Taichi-BIOS 4.60|2x16GB HyperX Predator RGB 3200@3600 1:1 IF|ASRock RX 6700XT|2 x PCIe 4.0 M.2 Drives for OS & Games|850 WTT Seasonic 80+ Titanium PSU|Noctua NH-D15|
|
|
![]() |
|
Argonaute
Newbie
Joined: 23 Nov 2020 Status: Offline Points: 1 |
Post Options
Thanks(0)
Quote Reply
Posted: 23 Nov 2020 at 4:52pm |
|
Board model:X470 Taichi
BIOS version:4.20 Combo-AM4 1.0.0.6 CPU:AMD Ryzen 7 2700X RAM:2 x G.Skill F4-3200C16-16GTZRX Notes: Dr Debug constantly shows codes : 'AA' or '30', but I don't find anywhere an explanation of these codes. |
|
![]() |
|
rush158
Newbie
Joined: 15 Nov 2020 Status: Offline Points: 1 |
Post Options
Thanks(0)
Quote Reply
Posted: 15 Nov 2020 at 3:45am |
|
I have the X570 Taichi on bios 3.60 with a Ryzen 3800X but it will not flash to 3.61 at any price -I have no issues but it keeps saying invalid file when i try to flash to 3.61 - I have a Ryzen 9 5900x on order - Should I be worried ? |
|
|
M.Beard
|
|
![]() |
|
jgaldon
Newbie
Joined: 30 Jul 2019 Location: France Status: Offline Points: 9 |
Post Options
Thanks(0)
Quote Reply
Posted: 11 Nov 2020 at 1:39pm |
|
Board: X570 Extreme4
BIOS 3.31 CPU: Ryzen 3700X RAM: 2 x HyperX Predator 16Gb + 2 x HyperX Predator 8Gb No issues! |
|
![]() |
|
Post Reply
|
Page <1 1112131415 17> |
|
Tweet
|
| Forum Jump | Forum Permissions ![]() You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |