7.1 channel output. How? |
Post Reply |
Author | |
dspevack
Newbie Joined: 27 Jan 2016 Status: Offline Points: 4 |
Post Options
Thanks(0)
Posted: 27 Jan 2016 at 1:54am |
I have a Z170 OC Formula. I have a soundblaster 7.1 channel card that I used in my previous PC.I was hoping to use onboard 7.1 for this PC instead. But I can't figure out how the few audio jacks on the back put out 8 channels. I see front, rear, center bass. For 7.1 that means 2 channels are missing. Can anyone explain to me how to hook up 7 speakers+sub to the output of the board? Thanks Dan
|
|
wardog
Moderator Group Joined: 15 Jul 2015 Status: Offline Points: 6447 |
Post Options
Thanks(0)
|
The manual is such a wonderful learning instrument.
Take a gander at the bottom of pg 11. |
|
dspevack
Newbie Joined: 27 Jan 2016 Status: Offline Points: 4 |
Post Options
Thanks(0)
|
The same chart is on my QIG. It didn't make sense to me that I would have to lose my line-in to do it.
Thanks for the clarification. Going back to soundblaster. Dan
|
|
wardog
Moderator Group Joined: 15 Jul 2015 Status: Offline Points: 6447 |
Post Options
Thanks(0)
|
Yea, unfortunately that the one bugaboo of it.
|
|
Post Reply | |
Tweet
|
Forum Jump | Forum Permissions You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |