Asrock B650 PRO RS expo problem

Message Topic Search Topic Options Post Reply Create New Topic Printable Version Translate Topic

   Hello,

I assembled a system with the following components:

Asrock B650 PRO RS motherboard

Patriot Viper Venom (2x16GB) DDR5 6000MHz CL30 RAM

Ryzen 7 7800X3D CPU

POWERCOLOR HELLHOUND RX 7900 XT GPU

Upon receiving the system, I enabled the XMP profile for the RAM at 6200MHz CL32. Unfortunately, this caused damage to both the motherboard and CPU, rendering them unusable. Upon inspection, I found that the BIOS version at the time was 1.21. The store where I purchased these components replaced both the motherboard and CPU. Now, my BIOS version is 2.02. Should I attempt to enable the XMP profile again? I doubt they will replace the components again if something goes wrong.

And additionally there was no expo profile

Author	Message Topic Search Topic Options Post Reply Create New Topic Printable Version Translate Topic
Counxe Members Profile Send Private Message Find Members Posts Add to Buddy List Newbie Joined: 24 Jul 2024 Status: Offline Points: 20	Post Options Post Reply Quote Counxe Report Post Thanks(0) Quote Reply Topic: Asrock B650 PRO RS expo problem Posted: 24 Jul 2024 at 10:51pm
	Hello, I assembled a system with the following components: Asrock B650 PRO RS motherboard Patriot Viper Venom (2x16GB) DDR5 6000MHz CL30 RAM Ryzen 7 7800X3D CPU POWERCOLOR HELLHOUND RX 7900 XT GPU Upon receiving the system, I enabled the XMP profile for the RAM at 6200MHz CL32. Unfortunately, this caused damage to both the motherboard and CPU, rendering them unusable. Upon inspection, I found that the BIOS version at the time was 1.21. The store where I purchased these components replaced both the motherboard and CPU. Now, my BIOS version is 2.02. Should I attempt to enable the XMP profile again? I doubt they will replace the components again if something goes wrong. And additionally there was no expo profile