Z390 Taichi Ultimate 00 30 4C |
Post Reply |
Author | |
prbrucre
Newbie Joined: 27 Dec 2018 Location: Pittsburhg Status: Offline Points: 13 |
Post Options
Thanks(0)
Posted: 27 Dec 2018 at 11:39am |
I built a new system with the Z390 Taichi Ultimate and on boot up I received the code 00 30 4C and nothing displayed on the monitor? Ideas?
Thanks, Rob. |
|
Rob Bruce
|
|
ASRock_TSD
ASRock_Official Joined: 20 Mar 2015 Status: Offline Points: 8727 |
Post Options
Thanks(0)
|
Dear Prbrucre,
Thank you for choosing ASRock. Regarding your case, we provide some suggestions to try: 1. Clear CMOS to load BIOS default. Please remove the power cord, and follow the user manual p21 to clear CMOS. http://asrock.pc.cdn.bitgravity.com/Manual/Z390%20Taichi%20Ultimate.pdf 2. Only install CPU and one stick memory to check if the system can boot into BIOS properly. 3. Please try to install one stick memory at A1, B1, A2 and B2 slot to check if the system can boot into BIOS properly. 4. Reinstall CPU and check if CPU socket pin is fine. 5. If it is possible, please change another CPU or DRAM to check if the system can boot into BIOS properly. Thank you! Yours truly, ASRock TSD |
|
prbrucre
Newbie Joined: 27 Dec 2018 Location: Pittsburhg Status: Offline Points: 13 |
Post Options
Thanks(0)
|
Thanks. I was able to system to boot to the bios.
-Rob. |
|
Rob Bruce
|
|
Post Reply | |
Tweet
|
Forum Jump | Forum Permissions You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |