Z390 Taichi code 00 |
Post Reply |
Author | |
autentic
Newbie Joined: 22 Jan 2019 Location: malaysia Status: Offline Points: 6 |
Post Options
Thanks(0)
Posted: 22 Jan 2019 at 8:55pm |
I am building a new computer with i7 8700, 2xG.Skill trident Z rgb 16Gb 3200, and 1 SSD samsung 970 Evo. The monitor displays nothing (connected with display port) and I get a 00 code.
I tried to use the clear cmos button. I did not find the jumper to clear the CMOS, but I remove the battery and tried the button. I removed the RAM and tried the A1, then the A2. I reinstalled the CPU after checking that it looked fine. I always get 00. any suggestion ? |
|
RLGL
Senior Member Joined: 29 Jul 2018 Location: MN Status: Offline Points: 1995 |
Post Options
Thanks(0)
|
Check this page; https://www.asrock.com/support/faq.asp?id=334 .Do you have the ATX 12 volt connector connected to the motherboard (CPU power)?
|
|
Asrock Z370 Gaming K6,Intel i7 8700K,
Asrock x570 Taichi |
|
autentic
Newbie Joined: 22 Jan 2019 Location: malaysia Status: Offline Points: 6 |
Post Options
Thanks(0)
|
I have the 8 pin connected but not the 4 pin. Should I connect both ?
|
|
RLGL
Senior Member Joined: 29 Jul 2018 Location: MN Status: Offline Points: 1995 |
Post Options
Thanks(0)
|
YES!
|
|
Asrock Z370 Gaming K6,Intel i7 8700K,
Asrock x570 Taichi |
|
autentic
Newbie Joined: 22 Jan 2019 Location: malaysia Status: Offline Points: 6 |
Post Options
Thanks(0)
|
How did you power the 8+4 pins ? do you have a cable 8 pins on one side and 8+4 pins on the other side.
|
|
autentic
Newbie Joined: 22 Jan 2019 Location: malaysia Status: Offline Points: 6 |
Post Options
Thanks(0)
|
on internet, they all say that the 4 pins is optional and only for overclocking.
For now I use only the 8 pins and the CPU is not warm |
|
ASRock_TSD
ASRock_Official Joined: 20 Mar 2015 Status: Offline Points: 8547 |
Post Options
Thanks(0)
|
Dear Autentic,
Thank you for choosing ASRock. Z390 Taichi provides an 8-pin ATX 12V and a 4-pin ATX 12V connector. If your power supply only have 8-pin cable, please connect the 8-pin connector and the system can boot up without problem. About the Debug code 00, it usually means the CPU problem. If possible, please change another CPU to try. Thank you! Yours truly, ASRock TSD |
|
Post Reply | |
Tweet
|
Forum Jump | Forum Permissions You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |