Cleaned/Rebuilt PC, RAM slots B1, B2 not working |
Post Reply |
Author | |
Travesty
Newbie Joined: 02 Jun 2019 Status: Offline Points: 4 |
Post Options
Thanks(0)
Posted: 02 Jun 2019 at 9:28am |
System was working fine before clean and rebuild (no components replaced) but afterward RAM in slots B1 and B2 is not recognized. If I put a stick (I have 2x8gb) in either slot I get 3 or 3+8 (3 followed by 8) BIOS beeps on boot, which I understand to mean errors with RAM. I am certain the RAM itself is not damaged, as I can place either stick (by itself) in either A1 or A2 and the system posts just fine with no mobo beeps. Below is a table of the possible RAM/slot combinations and the output:
A1+A2: Boots, shows 16gb installed (but my understanding is that in this config only 8gb is actually 'available' to be used?) A1 or A2 (single): Boots, shows 8gb installed A1+B1 or A2+B2: 3 BIOS beeps, boots, shows "16gb installed, 8gb usable" B1+B2: 3+8 BIOS beeps, does not boot B1 or B2: 3+8 BIOS beeps, does not boot Mobo: ASRock ab350m pro4 RAM: 2x8gb G.Skill TridentZ RGB 3000 MHz (DDR4) CPU: AMD Ryzen 5 1600 3.20 GHz (no overclock, standard cooling) GPU: Sapphire Radon RX480 8gb SSD: Samsung EVO m.2 512gb Power: Seasonic 520w 80+ Bronze How can I diagnose this problem? Is my mobo just fucked? Can I force the mobo to read ram from slots A1+A2 so I can get my full 16gb back? |
|
Travesty
Newbie Joined: 02 Jun 2019 Status: Offline Points: 4 |
Post Options
Thanks(0)
|
I got a couple suggestions on Reddit BuildAPC for possible solutions and tried them all with no success. Here's a link to the thread to show what I tried:
https://www.reddit.com/r/buildapc/comments/bvs3qe/tore_down_cleaned_and_rebuilt_pc_ram_slots_b1_and/ |
|
Post Reply | |
Tweet
|
Forum Jump | Forum Permissions You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |