ASRock.com Homepage
Forum Home Forum Home > Technical Support > AMD Motherboards
  New Posts New Posts RSS Feed - Rgb looks off white
  FAQ FAQ  Forum Search Search  Events   Register Register  Login Login

Rgb looks off white

 Post Reply Post Reply
Author
Message
Adamc03 View Drop Down
Newbie
Newbie


Joined: 07 Feb 2020
Location: Uk
Status: Offline
Points: 7
Post Options Post Options   Thanks (0) Thanks(0)   Quote Adamc03 Quote  Post ReplyReply Direct Link To This Post Topic: Rgb looks off white
    Posted: 07 Feb 2020 at 10:25am


I have set the RGB to white in the software, but the cover rgb look a bit red when white. This is for the asrock b450m steel legend atx board.
Back to Top
gizmic View Drop Down
Groupie
Groupie
Avatar

Joined: 13 Jun 2018
Location: Hong Kong
Status: Offline
Points: 677
Post Options Post Options   Thanks (0) Thanks(0)   Quote gizmic Quote  Post ReplyReply Direct Link To This Post Posted: 07 Feb 2020 at 10:40am
that means you have a burnt blue led which is common on heated areas
Back to Top
Adamc03 View Drop Down
Newbie
Newbie


Joined: 07 Feb 2020
Location: Uk
Status: Offline
Points: 7
Post Options Post Options   Thanks (0) Thanks(0)   Quote Adamc03 Quote  Post ReplyReply Direct Link To This Post Posted: 11 Feb 2020 at 12:33am
As you can see from the picture, the led is more purple than white.

http://imgur.com/a/Ju0Dpfl
Back to Top
Xaltar View Drop Down
Moderator Group
Moderator Group
Avatar

Joined: 16 May 2015
Location: Europe
Status: Offline
Points: 24653
Post Options Post Options   Thanks (0) Thanks(0)   Quote Xaltar Quote  Post ReplyReply Direct Link To This Post Posted: 11 Feb 2020 at 2:39am
It's a common issue with RGB LEDs that don't have a dedicated white diode. I can
never get any of my LED (RGB) strips properly white unless I use and RGBw strip.
The best you can usually achieve is to bring down the red slider a little and try
to balance them better. The LED will be dimmer but get at least a little closer
to white.

Also, as Gizmic noted, it can also happen when one of the LED diodes is
burned/weak. Again though, you can adjust sliders to try and balance it.
Back to Top
 Post Reply Post Reply
  Share Topic   

Forum Jump Forum Permissions View Drop Down

Forum Software by Web Wiz Forums® version 12.04
Copyright ©2001-2021 Web Wiz Ltd.

This page was generated in 0.281 seconds.