H510 Pro BTC+ GPU Issues |
Post Reply |
Author | |
Tai-Pan
Newbie Joined: 12 Jan 2022 Status: Offline Points: 35 |
Post Options
Thanks(0)
Posted: 12 Jan 2022 at 12:19pm |
* If I install GPUs in PCEI3, 4, 5 and 6 everything work as it should.
* If I also install a GPU in PCIE2 the system enters in the Bios and the only way to boot up is by manually going to EXIT -> Choosing the Manual SATA partition to boot from. It basically stops booting up automatically... No errors. * If I also install a GPU in PCIE1 the BIOS beeps 8 times (Display memory error) and halts * If I tried to install my 6 GPU in the USB Riser, nor the Bios or the Windows Device Manager shows the card installed. --- This happens in two different H510 motherboards, using GPU 6900XT, 2 and/or 3 1600W PSU and the bios updated to the latest version available 1.4 Did anybody run into similar issues, any solutions/workarounds that you found? I tried setting the PCIes to GEN2, and plenty of other Bios setting, and no solutions so far... ANY GOOD ADVICE IS MORE THAN WELCOME AT THIS POINT! THANKS |
|
threadzipper1957
Senior Member Joined: 05 Mar 2022 Status: Offline Points: 9335 |
Post Options
Thanks(0)
|
Dear Tai-Pan
Some graphics cards, have a problem with Clever Access memory (CAM) Always set CSM to disabled, and Above 4 G Decoding to enabled. Try disabling CAM, and check for the latest BIOS Also check all slots individually with only 1 card, to verify, they are working |
|
Kind Regards
|
|
Post Reply | |
Tweet
|
Forum Jump | Forum Permissions You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |