ASRock PG Riptide - Long boot screen |
Post Reply |
Author | |
sbrewer
Newbie Joined: 12 Mar 2022 Status: Offline Points: 115 |
Post Options
Thanks(0)
Posted: 12 Mar 2022 at 9:24am |
New system.
Flashed current bios. Loaded defaults. ASRock Logo displays for at least 60 sec with boot options. Selecting boot options does nothing to change boot time. Screen will eventually change to selection option... ie., boot menu or bios. Sometimes it takes several minutes to boot past the boot screen. |
|
Xaltar
Moderator Group Joined: 16 May 2015 Location: Europe Status: Offline Points: 22778 |
Post Options
Thanks(0)
|
Check to see if CSM is enabled or disabled in your UEFI. I suspect it may be set
to disabled by default with the new BIOS version. If your OS was installed with it enabled then the system will be unable to find your boot device until you manually select it from the boot menu. Enable CSM if it's disabled, disable it if enabled, see if that resolves the issue. |
|
|
|
sbrewer
Newbie Joined: 12 Mar 2022 Status: Offline Points: 115 |
Post Options
Thanks(0)
|
I don't see a CSM option.
ASRock Z690 PG Riptide i7-12700k Gigabyte GTX 1070ti (with uefi support) When I boot from the Windows 10 Installer on USB, it loads to the ASRock logo, on the bottom of the screen I get boot options. It stays here for anywhere from 60 secodns to several minutes. If I pick an option, it doesn't change any faster no matter whether I choose F2, F11, etc., When I get to the point where Windows spinner starts up on the lower part of the screen, it just hangs there for a very long time. I gave up after 5 minutes. I have never has a system take this long to boot past the BIOS screen. I have updated to the latest BIOS from the BIOS internet update tool. I load defaults. I try to boot from a Windows boot device, USB flash drive, USB hard drive, anything. Never works. I have booted Linux on here fine. Took a LONG time, but eventually worked. If I wait long enough it crashes to blue screen with upnp driver error. |
|
sbrewer
Newbie Joined: 12 Mar 2022 Status: Offline Points: 115 |
Post Options
Thanks(0)
|
Cleared cmos, again.
Booted to Windows install menu after 18 minutes. Sitting at Setup is starting for 30 minutes now, the busy timer still sittng there. I can move the mouse the the busy cursor moves. but nothing it happening. Help? |
|
sbrewer
Newbie Joined: 12 Mar 2022 Status: Offline Points: 115 |
Post Options
Thanks(0)
|
Flashed bios 3.02. Now I can boot rom USB devices.
Boot into Windows 10 setup. No sata drivers. Or is sata device not supported in this bios? Can't use the cd for drivers because no sata. Can't use the drivers on a flash drive, becasue it doesn't find them. What drivers are needed and how to I find them? When will a stable bios be available for this Motherboard and the i7 12700k? |
|
sbrewer
Newbie Joined: 12 Mar 2022 Status: Offline Points: 115 |
Post Options
Thanks(0)
|
Started this journey with 4.02 now I'[m at 3.02 and can't find stirage drivers for Windows installation.
|
|
sbrewer
Newbie Joined: 12 Mar 2022 Status: Offline Points: 115 |
Post Options
Thanks(0)
|
ASRock support said to return it. Waiting for replacement now.
|
|
Xaltar
Moderator Group Joined: 16 May 2015 Location: Europe Status: Offline Points: 22778 |
Post Options
Thanks(0)
|
Good luck, let us know how it turns out
|
|
|
|
Post Reply | |
Tweet
|
Forum Jump | Forum Permissions You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |