No POST when remapping Optane 800P, W480 |
Post Reply |
Author | |
Dtaibi
Newbie Joined: 30 Jun 2022 Location: MD, USA Status: Offline Points: 35 |
Post Options
Thanks(0)
Posted: 01 Jul 2022 at 1:13am |
Hello, I need help with the same situation. I have the W480 Creator MoBo, I have the optane 800P card inserted in M2_3. The documentation says that all three M2 slots on the W480 Board support optane, however under the UEFI EZ Mode main screen, M2_3 shows N/A. When I switch to Advanced mode -> Advanced -> Storage Configuration, M2_1, which is my Samsung 980 boot drive, and M2_3 show up for the option to remap. However when I enable the Teton Glacier mode AND enable remapping of the M2_3 optane drive, the board never boots and just continues to power cycle until the UEFI is reset to defaults. I have updated the W80 UEFI to the latest 1.50 firmware.
Please assist me as I would very much like to use this Optane 800P chip that I purchased! |
|
threadzipper1957
Senior Member Joined: 05 Mar 2022 Status: Offline Points: 9335 |
Post Options
Thanks(0)
|
Dear Dtaibi,
I think it would be best to use the tech support form https://event.asrock.com/tsd.asp It is possible to make BIOS screenshots, using a FAT formatted USB stick, just press F12 to make a screenshot. The information in the support form, will help to diagnose the problem. When using a gmail account, check the spam folder for a reply |
|
Kind Regards
|
|
Post Reply | |
Tweet
|
Forum Jump | Forum Permissions You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |