X300-ITX (x300 Deskmeet) Wake On Lan does not work

Hello, it had tried with linux and it works, but with both Windows 10 and 11 it is a no go, following the settings:

Realtek PCIe GbE Family Controller Proprieties - Advanced Tab

ARP Offload - Enabled
Flow Control - Rx & TX Enabled
Interupt Moderation - Enabled
PIv4 Checksum Offload - Rx & TX Enabled
Jumbo Frame - Disabled
Large Send Offload v2 (IPv4) - Enabled
Large Send Offload v2 (IPv6) - Enabled
Network Address - Not Present
NS Offload - Enabled
Priority & VLAN - Priority & VLAN Enabled
Receive Buffers - 512
Recv Segment Coalescing (IPv4) - Disabled
Recv Segment Coalescing (IPv6) - Disabled
Shutdown Wake-On-Lan - Enabled
Speed & Duplex - Auto Negotiation
TCP Checksum Offload (IPv4) - Rx & TX Enabled
TCP Checksum Offload (IPv6) - Rx & TX Enabled
Transmit Buffers - 128
UDP Checksum Offload (IPv4) - Rx & TX Enabled
UDP Checksum Offload (IPv6) - Rx & TX Enabled
VLAN ID - 0
Wake on Magic Packet - Enabled
Wake in pattern match - Enabled
WOL & Shutdown Link Speed - 10 Mbps First

Realtek PCIe GbE Family Controller Proprieties - Power Management Tab

Allow the computer to turn off this device to save power - Flagged
Allow this device to wake the computer - Flagged
     Onòy Allow a magic packet to wake the computer - Flagged

Advanced TCP/IP Settings - WINS Tab

Netbios setting - Default


Power Options
Profile - High Performance
PCI Express - Link State Power Management - Off


Turn on fast startup - Unflegged
Sleep - Flagged
Hibernate - Unflagged
Lock - Flagged


Any ideas on what is going on? Thank you all in advance :)