EPC602 long bios boot time and LED blinking

cool, let me know the outcome of that.

Thanks

hi H110,

the multiple boot screen might coming from BIOS checking for boot drive. so in my case, I do not use RAID, i turn off most of SATA (disable it). the problem of multiple boot screen is gone.

Thanks Badbri,

I was able to eliminate second ASROCK bios logo. I need to turn of some sata/raid that i dont need to use so it could skip booting from these sata port.

However, the first time boot is quite long. I takes few second to boot into ASROCK's BIOS logo. Is it normal?

Thanks

Thanks Badbri for rep,

I might not make clear myself. let me explain it again.

the long boot time due to starting machine (not boot into window because I am using SSD). Also the "ASROCK" logo appears twice, so its likely that the BIOS boot twice. it might relate to SATA I and other controller that i have not disable yet.

about the manual which manual are you referring to? I have read the manual comes with the board and it only has 74 pages. the online version slightly different but it stops at 75.

Thanks

Hi all, I just bought this mother board EPC602D8A to build a budget workstation, and i have few things that I am not sure about (first time with ASROCK mother board). Before I go to describe my problem, I will list my system here first:

mother board: EPC602D8A
CPU: Xeon E5-2690 V2
Ram: ECC DDR3
Graphic: Quadro 4000

- the first problem is that the when I turn on the board, I have to wait few (10-20) seconds to have the screen display ASROCK bios on monitor through display port on the graphic card.
- the second problem is that the LED next to the second from bottom PCIe x8 slot keep blinking. I tried to read in the manual but it does not mention about that LED.


Thanks