![]() |
B365M Phantom Gaming 4 OC not available |
Post Reply ![]() |
Author | |
hoockian ![]() Newbie ![]() Joined: 08 Jun 2023 Status: Offline Points: 35 |
![]() ![]() ![]() ![]() ![]() Posted: 08 Jun 2023 at 8:05pm |
Hello, I have an ASROCK B365M Phantom Gaming 4, BIOS version P4.30, I installed a 2666Ghz DDR4 memory, but from the BIOS it won't let me set the frequency, any solution?, I have looked in google and help but I can't find a solution, according to ASRock this board supports up to 2666Ghz. thank you so much
|
|
![]() |
|
Xaltar ![]() Moderator Group ![]() ![]() Joined: 16 May 2015 Location: Europe Status: Offline Points: 23993 |
![]() ![]() ![]() ![]() ![]() |
Under the "OC Tweaker" tab in your UEFI, DRAM Settings -> Load XMP - Enable.
|
|
![]() |
|
![]() |
|
hoockian ![]() Newbie ![]() Joined: 08 Jun 2023 Status: Offline Points: 35 |
![]() ![]() ![]() ![]() ![]() |
Thanks for helping,
What you tell me about XMP Load in my BIOS P4.30 does not appear, and manually it only leaves me up to 2400, I am desperate since I bought the new T-Forge RAM from Teamgroup and I am not getting any performance out of it. Greetings |
|
![]() |
|
Xaltar ![]() Moderator Group ![]() ![]() Joined: 16 May 2015 Location: Europe Status: Offline Points: 23993 |
![]() ![]() ![]() ![]() ![]() |
If the setting is missing then it's likely intel forced ASRock to remove it. Technically
XMP is "overclocking" which intel only allow on their z series chipsets. Motherboard manufacturers often enable XMP anyway but intel will sometimes get angry and force them to remove it again. That said, if your RAM is 2666 you are not missing out on any noticeable performance if you are running at 2400. In games you will not see more than a single FPS difference in most titles. The difference between 2666 and 2400 is actually very small in practical use. Edited by Xaltar - 10 Jun 2023 at 11:21pm |
|
![]() |
|
![]() |
|
Alikhan ![]() Newbie ![]() ![]() Joined: 08 Jun 2023 Location: jahlem Status: Offline Points: 60 |
![]() ![]() ![]() ![]() ![]() |
"Hi there, I had a similar issue with my ASRock B365M Phantom Gaming 4 motherboard. Updating the BIOS to the latest version and enabling the XMP/DOCP profile did the trick for me. Make sure to follow the instructions provided by ASRock carefully. If you're still facing difficulties, reaching out to ASRock's technical support could provide further assistance tailored to your specific motherboard model. Good luck! Best regards," Edited by Xaltar - 08 Aug 2023 at 2:50am |
|
![]() |
Post Reply ![]() |
|
Tweet
|
Forum Jump | Forum Permissions ![]() You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |