X99 Extreme 4 | Turns off immediately after power |
Post Reply | Page <1 234 |
Author | |
jsarath
Newbie Joined: 17 Jan 2016 Status: Offline Points: 14 |
Post Options
Thanks(0)
|
I have the CM 690 III, and yes I have one raiser on the case per mounting hole in motherboard.
I have two cards - one the graphics card and other other a PCIE Wifi Card. I don't see any of them twisted/bent. While I would like to believe that it was a short, it still eludes me as to why I got the error when I breadboarded the setup until I powered the rig without the CMOS battery. I sent back the new PSU that I had ordered (everything that I did yesterday was with the Old PSU - old as in 1.5 years). I also ordered a new bunch of SATA cables as the ones currently in use are remains from the old build. Nothing was added to the build since I added a BluRay Writer, and it was in November '15.
|
|
wardog
Moderator Group Joined: 15 Jul 2015 Status: Offline Points: 6447 |
Post Options
Thanks(0)
|
Why I asked is there are/were a few cases that Users reported shorting going on.
The CM 690 II, not III, was one. Another that comes to mind was my beloved Fractal Design, if forget which model. When you reinstall the MB take care not to "force' it up tight to the leading edge at the back of the case. |
|
Post Reply | Page <1 234 |
Tweet
|
Forum Jump | Forum Permissions You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |