|
Question for taichi users |
Post Reply 
|
| Author | |
Asingo 
Newbie 
Joined: 02 Jul 2017 Status: Offline Points: 111 |
 Post Options
 Thanks(0)
 Quote Reply
 Topic: Question for taichi usersPosted: 20 Sep 2017 at 6:52am |
 |
|
|
Asingo
Newbie
Joined: 02 Jul 2017 Status: Offline Points: 111 |
Post Options
Thanks(0)
Quote Reply
Posted: 21 Sep 2017 at 12:32am |
|
bump
- Do you know maybe which version of corsair ram is mine? I use CMK16GX4M2B3200C16. On taichi QVL is listed this memorys: CMK16GX4M2B3000C15 ver:5.30, CMK16GX4M2B3000C15 ver 4.23 and CMK16GX4M2B3000C15 ver3.32. Mine is between them? All that are listed on 3000mhz C15 so I should be able to hit minimum 3000mhz with current bios? - Will I with wifi on taichi have good signal since my router is on the floor below, 7 meters away from my pc? |
|
|
|
|
quicknick
Newbie
Joined: 22 Apr 2017 Location: Romania Status: Offline Points: 79 |
Post Options
Thanks(0)
Quote Reply
Posted: 21 Sep 2017 at 7:29am |
|
I have the exact same memory. Not one but two kits for a total of 32GB. Runs flawless at 3066 with bios 2.40.
With older bioses I was stuck at 2666 with all four dimms, or 3200 very unstable using a single kit. I haven't tested a single kit with the newer bioses, but I imagine stable 3200 or even more is now possible. Regarding other questions, I find the board to be stable and quiet. No noise from the board itself, also audio output is clean and of quite good quality. Cannot say about wifi since I haven't used it, in fact I did not install the antennas... |
|
|
|
|
Asingo
Newbie
Joined: 02 Jul 2017 Status: Offline Points: 111 |
Post Options
Thanks(0)
Quote Reply
Posted: 21 Sep 2017 at 3:22pm |
you just load xmp profile or did you need to raise soc voltage, timmings and other things?
|
|
|
|
|
quicknick
Newbie
Joined: 22 Apr 2017 Location: Romania Status: Offline Points: 79 |
Post Options
Thanks(0)
Quote Reply
Posted: 22 Sep 2017 at 9:11am |
|
Enable xmp and bump down frequency from 3200 to 3066, I don't remember altering other settings. Though maybe I did and forgot, I'm not that young anymore and haven't touched the bios since June :)
I think soc voltage goes to 1.1 automatically with the higher freqs. |
|
|
|
|
Post Reply
|
|
Tweet
|
| Forum Jump | Forum Permissions You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |
Topic Options
quicknick wrote: