ASRock.com Homepage
Forum Home Forum Home > Technical Support > Intel Motherboards
  New Posts New Posts RSS Feed - W10 restarts after 24 hours
  FAQ FAQ  Forum Search Search  Events   Register Register  Login Login

W10 restarts after 24 hours

 Post Reply Post Reply
Author
Message
Ken429 View Drop Down
Newbie
Newbie


Joined: 30 Sep 2015
Location: Indiana
Status: Offline
Points: 225
Post Options Post Options   Thanks (0) Thanks(0)   Quote Ken429 Quote  Post ReplyReply Direct Link To This Post Topic: W10 restarts after 24 hours
    Posted: 06 Feb 2016 at 4:59am
I have several W10 systems and only one, that I'm aware of, has this obsession to automatically restart itself from a shutdown state after exactly 24 hours. I have checked this behavior for four 24 hour periods and it does it every time. All of the systems have about the same software and the same tasks in Task Manager. In fact, I have two systems with almost exactly the same hardware (Z97 Extreme6/4790K, BIOS Version P2.50), Sandisk Extreme Pro 240GB boot drive etc.) - one restarts itself and the other does not. Both systems have a relatively new fresh install of W10 v1511. I don't know if this is a W10 or a Z97 Extreme6 BIOS issue but I sure would appreciate some suggestions on where or what I should be looking at to make the problem system behave "normally". 


Edited by Ken429 - 06 Feb 2016 at 5:04am
Back to Top
Ken429 View Drop Down
Newbie
Newbie


Joined: 30 Sep 2015
Location: Indiana
Status: Offline
Points: 225
Post Options Post Options   Thanks (0) Thanks(0)   Quote Ken429 Quote  Post ReplyReply Direct Link To This Post Posted: 25 Feb 2016 at 8:45pm
Not getting much help with this issue!  (Also Posted on Ten Forums) 

Just to add to my woes, I now have two machines that restart themselves EXACTLY 24 hours to the second after they have been SHUTDOWN. The problem has probably been on both systems all along I just never paid close attention to why they were in sleep mode - I just assumed I forgot to shut them down! Both systems are built on an ASRock Z97 Extreme6 MB and a 4790K processor running with default BIOS settings. Both systems have a relatively fresh install of W10 v1511. I have two other systems built on an ASRock Z77 Extreme4 MB with a 3770K processor and a 2600K processor. Neither of these two systems have the problem. All four systems have the same software installed! I can't believe I'm the only one in the world with this issue, minor though it may be?

Edited by Ken429 - 25 Feb 2016 at 8:47pm
Back to Top
Xaltar View Drop Down
Moderator Group
Moderator Group
Avatar

Joined: 16 May 2015
Location: Europe
Status: Offline
Points: 25073
Post Options Post Options   Thanks (0) Thanks(0)   Quote Xaltar Quote  Post ReplyReply Direct Link To This Post Posted: 25 Feb 2016 at 11:41pm
Hmm, an easy way to test if it is the system or the OS: 

1. Shut down the system and disconnect the drives from the motherboard. 
2. Wait 24h and see if the system powers itself on again
3. If yes, turn off again and wait another 24h and see if it repeats this.

If it is the system itself then step 3 should power the system on 24h later, if not it should remain off.

To be absolutely sure you can

4. Turn off the system leaving the drives disconnected.
5. Disconnect the power.
6. Clear CMOS using this method.
7. Power the system and enter BIOS.
8. Turn off using the power button.
9. Wait 24h and see if it powers up.

If the system powers on after clearing CMOS with no drives connected then it is a system related issue. I highly doubt it will prove to be the case but the above steps will definitively determine where the issue is coming from so at least you will know where to seek further assistance.

Good luck


Edited by Xaltar - 25 Feb 2016 at 11:42pm
Back to Top
Ken429 View Drop Down
Newbie
Newbie


Joined: 30 Sep 2015
Location: Indiana
Status: Offline
Points: 225
Post Options Post Options   Thanks (0) Thanks(0)   Quote Ken429 Quote  Post ReplyReply Direct Link To This Post Posted: 01 Mar 2016 at 6:54pm
Problem solved!  Disabled the Intel Smart Connect Technology option in the BIOS and the Reboot issue goes away.  Apparently the ASRock Extreme6 BIOS implementation of the Z97 chip is a little different than the Extreme4 Z77 implementation.  The Default setting on both MB's was Enabled yet the Z77's (at least mine) don't have the Reboot "problem".  The guys on the Malwarebytes Forum jumped all over me when I tried to blame that program.  They directed me to the BIOS issue almost immediately!
Back to Top
parsec View Drop Down
Moderator Group
Moderator Group
Avatar

Joined: 04 May 2015
Location: USA
Status: Offline
Points: 4996
Post Options Post Options   Thanks (0) Thanks(0)   Quote parsec Quote  Post ReplyReply Direct Link To This Post Posted: 01 Mar 2016 at 11:36pm
Originally posted by Ken429 Ken429 wrote:

Problem solved!  Disabled the Intel Smart Connect Technology option in the BIOS and the Reboot issue goes away.  Apparently the ASRock Extreme6 BIOS implementation of the Z97 chip is a little different than the Extreme4 Z77 implementation.  The Default setting on both MB's was Enabled yet the Z77's (at least mine) don't have the Reboot "problem".  The guys on the Malwarebytes Forum jumped all over me when I tried to blame that program.  They directed me to the BIOS issue almost immediately!


No idea why Smart Connect is not starting your other PC, but that's how it works. Start the PC to update your email, etc, so you don't need to wait for it to happen when you are ready to use the PC. I don't see how useful that is with our current PCs and Internet, but I suppose someone uses it.

I'm so used to disabling that option that I don't even think about it.

That's why I use UEFI/BIOS profiles, to restore my settings after a UEFI clear. A UEFI update requires us to rebuild our profiles, and I pretty much burn right through all the options in the Advanced screen like a robot to set them "right" for me.
Back to Top
 Post Reply Post Reply
  Share Topic   

Forum Jump Forum Permissions View Drop Down

Forum Software by Web Wiz Forums® version 12.04
Copyright ©2001-2021 Web Wiz Ltd.

This page was generated in 0.156 seconds.