GENOAD8X-2T issues

Message Topic Search Topic Options Post Reply Create New Topic Printable Version Translate Topic

   Hi,

My new homelab setup is:

Asrock GENOAD8X-2T/BCM (Bios 1.13)
AMD EPYC 9124
4x 32GB Micron MTC20F2085S1RC48BA1
2x KINGSTON SNV3S2000G M2 NVME

I have 2 active problems with this board:

1. BIOS never sees Kingston NVME in slot M2_1. All is enabled, PCIe mode selected - nothing. Switched with other identical NVME - still nothing. M2_2 slot is fine for both NVMEs. Tried to force Gen4 PCIe, still nothing.

2. I installed 3x Noctua NF-A14 PWM fans to slots FAN_3 to FAN_5. These are 4 pin fans. They constantly get fan failure events (speed reading issues according to BMC). Changed thresholds to 0, NA - nothing. At least I found out how to turn off max fan when failure, otherwise they were constantly changing speed to low -> high -> low ... CPU fan is in slot 1, also 4 pin fan, no issues.

Been reading the manual end to end, myself, chatgpt... but still nothing.

Author	Message Topic Search Topic Options Post Reply Create New Topic Printable Version Translate Topic
RassK Members Profile Send Private Message Find Members Posts Add to Buddy List Newbie Joined: 5 hours 39 minutes ago Location: Estonia Status: Offline Points: 20	Post Options Post Reply Quote RassK Report Post Thanks(0) Quote Reply Topic: GENOAD8X-2T issues Posted: 5 hours 22 minutes ago at 7:47am
	Hi, My new homelab setup is: Asrock GENOAD8X-2T/BCM (Bios 1.13) AMD EPYC 9124 4x 32GB Micron MTC20F2085S1RC48BA1 2x KINGSTON SNV3S2000G M2 NVME I have 2 active problems with this board: 1. BIOS never sees Kingston NVME in slot M2_1. All is enabled, PCIe mode selected - nothing. Switched with other identical NVME - still nothing. M2_2 slot is fine for both NVMEs. Tried to force Gen4 PCIe, still nothing. 2. I installed 3x Noctua NF-A14 PWM fans to slots FAN_3 to FAN_5. These are 4 pin fans. They constantly get fan failure events (speed reading issues according to BMC). Changed thresholds to 0, NA - nothing. At least I found out how to turn off max fan when failure, otherwise they were constantly changing speed to low -> high -> low ... CPU fan is in slot 1, also 4 pin fan, no issues. Been reading the manual end to end, myself, chatgpt... but still nothing.