ASRock.com Homepage
Forum Home Forum Home > Technical Support > Intel Motherboards
  New Posts New Posts RSS Feed - ASRockRack Server Management Utility login fail
  FAQ FAQ  Forum Search Search  Events   Register Register  Login Login

ASRockRack Server Management Utility login fail
 Post Reply Post Reply
Author
Message Reverse Sort Order
  Topic Search Topic Search  Topic Options Topic Options
threadzipper1957 View Drop Down
Senior Member
Senior Member
Avatar

Joined: 05 Mar 2022
Status: Offline
Points: 9365 		Post Options Post Options   Thanks (0) Thanks(0)   Quote threadzipper1957 Quote  Post ReplyReply Direct Link To This Post Topic: ASRockRack Server Management Utility login fail
    Posted: 21 Jun 2023 at 11:22pm
It would be best to use the Server Workstation department support
https://event.asrockrack.com/tsd.asp
And please check your spam folder for replies
Kind Regards
Back to Top
vankilo View Drop Down
Newbie
Newbie


Joined: 16 May 2023
Status: Offline
Points: 20 		Post Options Post Options   Thanks (0) Thanks(0)   Quote vankilo Quote  Post ReplyReply Direct Link To This Post Posted: 16 May 2023 at 12:55am
Hi,

I have the E3C236D2I motherboard with BMC and IPMI/KVM support.

I tried using the ASRockRack Server Management Utility available here https://www.asrockrack.com/support/SMU.asp to control the board with no success so far.

The BMC ip address is set through DHCP to 192.168.1.54.
I am able to connect to http://192.168.1.54 with admin/admin credentials and configure some things from there.

But the login to the board with the same admin/admin credentials through asrrmgmttool (Server Management Utility) fails using CLI or GUI.

On linux, executing the following:


> ./asrrmgmttool power status -h 192.168.1.54 -u admin -p admin


gives:


Power control...status
192.168.1.54: login failed
Total servers found: 1, command sent: 0, failed: 1
Failed servers: 192.168.1.54


Same on windows.

However, I can control the board with the "standard" ipmitool on linux with no issue.

For example, the following works just fine:


> ipmitool power status -H 192.168.1.54 -U admin -P admin


Does anyone have a clue about what should be done to login successfully ?

Thanks
Back to Top
 Post Reply Post Reply
  Share Topic   

Forum Jump Forum Permissions View Drop Down

Forum Software by Web Wiz Forums® version 12.04
Copyright ©2001-2021 Web Wiz Ltd.

This page was generated in 0.107 seconds.