Asrock Z75 pro 3 issue |
Post Reply | Page 12> |
Author | |
wenqdu
Newbie Joined: 18 Dec 2015 Location: GA Status: Offline Points: 10 |
Post Options
Thanks(0)
Posted: 18 Dec 2015 at 1:21am |
Hi Asrock, just yesterday I started noticing the system time is off and it never syncs, I tried various MS updates and fixes they had available on their site; but the system is still not syncing correctly.
I'm thinking the CMOS battery is starting to die off. Any chance I can get a replacement? This item was purchased last year October or November, I can't remember which. Please help
|
|
wardog
Moderator Group Joined: 15 Jul 2015 Status: Offline Points: 6447 |
Post Options
Thanks(0)
|
CMOS batteries are available at most any drug store and most grocery stores too.
It is most likely a CR2032 button cell, but it's best to look at the battery itself as law req's it to be stamped on the.. $2.00USD, tops. |
|
wenqdu
Newbie Joined: 18 Dec 2015 Location: GA Status: Offline Points: 10 |
Post Options
Thanks(0)
|
I will take a look, thank you sir!
|
|
wardog
Moderator Group Joined: 15 Jul 2015 Status: Offline Points: 6447 |
Post Options
Thanks(0)
|
You're welcome.
Be sure that when you replace in back in it's holder that the writing is visible/facing you. |
|
wenqdu
Newbie Joined: 18 Dec 2015 Location: GA Status: Offline Points: 10 |
Post Options
Thanks(0)
|
Will do!
|
|
wenqdu
Newbie Joined: 18 Dec 2015 Location: GA Status: Offline Points: 10 |
Post Options
Thanks(0)
|
Hey Asrock, I put in a new cmos battery and it's still not working. I think the board might be bad? Can I get a replacement?
|
|
Xaltar
Moderator Group Joined: 16 May 2015 Location: Europe Status: Offline Points: 25058 |
Post Options
Thanks(0)
|
Once you install a new battery it is always good practice to clear CMOS completely. Turn off the system, disconnect the power from the PSU then depress the power button to be sure it isn't carrying any charge then clear CMOS and remove the battery. Leave it like this for about 10 - 20 mins then put the battery back in and set the clear jumper back to its original position. Power up the system and then sync your time again, try different servers if you have to.
|
|
wenqdu
Newbie Joined: 18 Dec 2015 Location: GA Status: Offline Points: 10 |
Post Options
Thanks(0)
|
Heya Xaltar, yeah I already did all of that :( It's still not syncing unfortunately :(
|
|
wardog
Moderator Group Joined: 15 Jul 2015 Status: Offline Points: 6447 |
Post Options
Thanks(0)
|
Most likely then the crystal got kiltered.
Go to the below and select Repair / RMA http://www.asrock.com/support/index.asp |
|
wenqdu
Newbie Joined: 18 Dec 2015 Location: GA Status: Offline Points: 10 |
Post Options
Thanks(0)
|
I don't know what i did, but it seemed to have been corrected after a couple more reboots. But now it won't recognize all of my ram sticks. I tested the ram sticks in pairs on all 4 slots; they were all recognized, but not when all 4 slots are filled.
|
|
Post Reply | Page 12> |
Tweet
|
Forum Jump | Forum Permissions You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |