ASRock.com Homepage
Forum Home Forum Home > Technical Support > Intel Motherboards
  New Posts New Posts RSS Feed - ASRock 775Dual-VSTA & SSD - in BIOS not detected
  FAQ FAQ  Forum Search Search  Events   Register Register  Login Login

ASRock 775Dual-VSTA & SSD - in BIOS not detected
 Post Reply Post Reply
Author
Message Reverse Sort Order
  Topic Search Topic Search  Topic Options Topic Options
Caravanj View Drop Down
Newbie
Newbie


Joined: 03 Jun 2019
Status: Offline
Points: 3 		Post Options Post Options   Thanks (0) Thanks(0)   Quote Caravanj Quote  Post ReplyReply Direct Link To This Post Topic: ASRock 775Dual-VSTA & SSD - in BIOS not detected
    Posted: 15 Jun 2019 at 6:59pm
Originally posted by Caravanj Caravanj wrote:

I've got a 775Twins HDTV motherboard & I had a similar problem insomuch as the BIOS saw the Crucial SSD card (which was recommended by Crucial), the SATA Controller showed in Device Manager but the drive didn't show in either Device Manager or Disk Management.
The SSD card was recognised when I put it in a USB enclosure so not an SSD card issue.
Eventually I changed the BIOS setting for- Advanced - IDE Configuration - ATA Combination Mode - from Disabled to Enabled.
The PC then dual-booted up from the SSD card into both Windows 7 & Windows 10.
However, with ATA Combination Mode = Enabled, the PC will only support one SATA device so I can only have the Crucial SSD card & no other SATA devices.
The IDE secondary channel still works & the CD drive shows up.
With the ATA Combination Mode = Disabled, the PC will start to boot up from the SSD so it's not an MBR issue) but then hangs for a few seconds & then restarts the PC.
P.S. Non-raid is the recommended BIOS setting although mine worked on both.


Ok, I got round the problem by installing a £16 4 port PCI to SATA card into one of the PCI slots (PCI, not PCIe).
The boot drive SSD is connected to the motherboard SATA port one & the secondary SSD drive is connected to a port on the PCI to SATA card.
BIOS is set to ATA Combination Mode = Enabled so only SATA port one on the motherboard works but all four SATA ports on the PCI to SATA card work.
Back to Top
Caravanj View Drop Down
Newbie
Newbie


Joined: 03 Jun 2019
Status: Offline
Points: 3 		Post Options Post Options   Thanks (0) Thanks(0)   Quote Caravanj Quote  Post ReplyReply Direct Link To This Post Posted: 03 Jun 2019 at 7:34pm
I've got a 775Twins HDTV motherboard & I had a similar problem insomuch as the BIOS saw the Crucial SSD card (which was recommended by Crucial), the SATA Controller showed in Device Manager but the drive didn't show in either Device Manager or Disk Management.
The SSD card was recognised when I put it in a USB enclosure so not an SSD card issue.
Eventually I changed the BIOS setting for- Advanced - IDE Configuration - ATA Combination Mode - from Disabled to Enabled.
The PC then dual-booted up from the SSD card into both Windows 7 & Windows 10.
However, with ATA Combination Mode = Enabled, the PC will only support one SATA device so I can only have the Crucial SSD card & no other SATA devices.
The IDE secondary channel still works & the CD drive shows up.
With the ATA Combination Mode = Disabled, the PC will start to boot up from the SSD so it's not an MBR issue) but then hangs for a few seconds & then restarts the PC.
P.S. Non-raid is the recommended BIOS setting although mine worked on both.
Back to Top
codeAR View Drop Down
Newbie
Newbie


Joined: 23 Feb 2019
Status: Offline
Points: 3 		Post Options Post Options   Thanks (0) Thanks(0)   Quote codeAR Quote  Post ReplyReply Direct Link To This Post Posted: 23 Feb 2019 at 11:41pm
Hello everybody,

for my computer with an ASRock 775Dual-VSTA motherboard, I have recently - for the purpose of full hard drive - installed a second hard drive.
This is a Samsung V-NAND SSD 860 EVO.

After I connected the hard drive to the mainboard using a SATA cable, the BIOS still shows "not detected" at the corresponding SATA port.
The mainboard should basically support SSDs (see, for example, this Crucial offer: https://www.crucial.de/deu/de/upgrad...k/775dual-vsta).

What can I do to make this ASRock motherboard and SSD hard drive work together?
Unfortunately my BIOS selection options are limited (essentially only "RAID" and "NON-RAID" - both variants unsuccessful). Also, a BIOS update does not make sense to me, as the "unofficial" 3.19a release, according to changelog, does not offer any relevant changes for SSDs.

Many thanks in advance for any support!
Back to Top
 Post Reply Post Reply
  Share Topic   

Forum Jump Forum Permissions View Drop Down

Forum Software by Web Wiz Forums® version 12.04
Copyright ©2001-2021 Web Wiz Ltd.

This page was generated in 0.047 seconds.