Beebox N3000 nuc - boot problem

Message Topic Search Topic Options Post Reply Create New Topic Printable Version Translate Topic

   Hello everyone. I recently had a problem starting up my Beebox pc. Normally he starts up in a proper way entering the Windows 10 desktop. He does this correctly when the 12 V power cable stays connected. If I disconnect the power cable (even for a few seconds) then, after reconnecting the power cable, the Beebox starts up to a black screen with a message that the time and date are not set. When I then choose F2 to enter the Bios/UEFI, on the contrary I notice that date/time is well set correctly. I choose then F10 tot save changes and leave Bios and enter finally the Windows 10 desktop correctly. Each time the 12v cable is plugged out , for some reason, the start up routine obliges me to first pass the Bios window before entering Windows. If the power cable stays connected to the pc, it starts up correctly. I replaced already the Bios battery by a new one, I already did an instant flash of the latest Bois version . But still the problem remains. Has someone an idea what causes this kind of problem. I am looking forward to get some information about this problem. It will be appreciated. Thanks in advance.
Kind regards 
Claude

Author	Message Topic Search Topic Options Post Reply Create New Topic Printable Version Translate Topic
Claude Members Profile Send Private Message Find Members Posts Add to Buddy List Newbie Joined: 22 Sep 2023 Location: Belgium Status: Offline Points: 35	Post Options Post Reply Quote Claude Report Post Thanks(0) Quote Reply Topic: Beebox N3000 nuc - boot problem Posted: 22 Sep 2023 at 8:57pm
	Hello everyone. I recently had a problem starting up my Beebox pc. Normally he starts up in a proper way entering the Windows 10 desktop. He does this correctly when the 12 V power cable stays connected. If I disconnect the power cable (even for a few seconds) then, after reconnecting the power cable, the Beebox starts up to a black screen with a message that the time and date are not set. When I then choose F2 to enter the Bios/UEFI, on the contrary I notice that date/time is well set correctly. I choose then F10 tot save changes and leave Bios and enter finally the Windows 10 desktop correctly. Each time the 12v cable is plugged out , for some reason, the start up routine obliges me to first pass the Bios window before entering Windows. If the power cable stays connected to the pc, it starts up correctly. I replaced already the Bios battery by a new one, I already did an instant flash of the latest Bois version . But still the problem remains. Has someone an idea what causes this kind of problem. I am looking forward to get some information about this problem. It will be appreciated. Thanks in advance. Kind regards Claude

Xaltar Members Profile Send Private Message Find Members Posts Add to Buddy List Moderator Group Joined: 16 May 2015 Location: Europe Status: Offline Points: 24653	Post Options Post Reply Quote Xaltar Report Post Thanks(0) Quote Reply Posted: 22 Sep 2023 at 10:39pm
	It sounds like the CMOS battery is weak/dying. Replacing it should resolve the issue.


Claude Members Profile Send Private Message Find Members Posts Add to Buddy List Newbie Joined: 22 Sep 2023 Location: Belgium Status: Offline Points: 35	Post Options Post Reply Quote Claude Report Post Thanks(0) Quote Reply Posted: 25 Sep 2023 at 11:39pm
	Thank you for your reply ; I already did replace the CMOS battery . But another problem occurred ??now the pc shows a grey coloured screen without any possibility to respond or give commands ??I fear the Beebox has reached the end of his life. By no means I can start it up in a decent way . The only way is entering the Bios but afterwards, the pc doesn?�t respond anymore when Windows starts up??no matter what I tried. Anyway I thank you for your advice. Kind regards , Claude