Failed update BIOS on conroexfire-esata2 |
Post Reply |
Author | |
youthMP
Newbie Joined: 24 Jul 2015 Location: Madeira Status: Offline Points: 5 |
Post Options
Thanks(1)
Posted: 25 Jul 2015 at 12:42am |
Thanks Xaltar I will now proceed to your resolution and see if it works. Yes odiebugs, I can enter into the bios when the system runs and don't blackscreen, but still I don't know properly how to work with the menus. As I could understand what your suggesting is formatting the computer but I wouldn't like to loose all the data stored so I will try first Xaltar suggestion. Thank you both for your attention.
Bernardo Reis
|
|
Xaltar
Moderator Group Joined: 16 May 2015 Location: Europe Status: Offline Points: 24743 |
Post Options
Thanks(0)
|
Am I correct in understanding that the system froze at the windows boot screen after the bios flash and then would no longer post after the error?
The first thing I would try in your situation is a full CMOS clear 1. Disconnect the power cord 2. Press the power button and hold it until all lights on the motherboard go out 3. Place the clear CMOS jumper in the clear CMOS position 4. Remove the CMOS battery 5. Leave the system like this for at least 4 hours 6. Replace the CMOS battery 7. Put the clear CMOS jumper back to its default position (pins 1 and 2) 8. Reconnect the power cord 9. Power up the system If I am understanding you correctly the system posted after the bios flash and then only after the freeze failed to post, hopefully it was the result of some corrupt settings in the bios post flash, in which case the clear CMOS step above should correct it. Good luck
|
|
odiebugs
Newbie Joined: 07 Jul 2015 Status: Offline Points: 193 |
Post Options
Thanks(0)
|
Welcome to the board.
If you bricked the BIOS, you wouldn't see anything, and never windows logo, I think you've caused a windows problem. I don't know what your BIOS version was, but the last three had a specific reason to update, and unless you needed them you shouldn't have upgraded. Remove the hard drive, and try booting and going into the BIOS, look at the storage settings as change as needed . If you can enter it, it's not bricked. Now I would attach the hard drive and reboot and enter BIOS and check boot drive settings. If windows doesn't boot, try using the windows disk and repair windows.
Edited by odiebugs - 24 Jul 2015 at 9:46am |
|
asrocking
|
|
youthMP
Newbie Joined: 24 Jul 2015 Location: Madeira Status: Offline Points: 5 |
Post Options
Thanks(0)
|
Hey all, today I found a little problem upgrading my BIOS motherboard which model is "conroexfire-esata2" in order to improve development. I successfully installed the software which I downloaded from ASrock website but then when I rebooted my computer It was 'bricked' , after windows loading menu appears it all went blue screen and just won't move it from there.
I tried removing battery from motherboard and put it again and nothing happened. By the way I'm no computer geek so I would like some Info about what should I do in order to restore BIOS and the normal function of the motherboard. Thank you for your attention, Looking forward for an awnser, Bernardo Reis.
|
|
Post Reply | |
Tweet
|
Forum Jump | Forum Permissions You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |